How can I get Intellikey to work on my Nissan?
Open the drivers side door of the vehicle and get in the vehicle. Close the door. Press the lock button on the drivers side door to lock all the doors. 3. Insert your key into the ignition and remove it at least 6 times. It may take up to 10 times. This needs to be done in a good pace, but not too fast.
How to program a Nissan Intellikey fob remote?
Push any button on your key-less entry FOB remote ONCE. This should be done within 5 seconds of turning the key to ACC. You should notice your hazards flash again. If you have another remote to program proceed to step 5, otherwise turn the key off and remove it.
Is there a way to program an Intellikey?
If you have another key-less entry remote to program unlock the door with the drivers side power lock and then lock them again. Press any button on the next remote. Turn the key back to the original position and remove the key. The remotes should now be programmed. I don’t think this procedure works for intellikey.
Open the drivers side door of the vehicle and get in the vehicle. Close the door. Press the lock button on the drivers side door to lock all the doors. 3. Insert your key into the ignition and remove it at least 6 times. It may take up to 10 times. This needs to be done in a good pace, but not too fast.
What can you do with Nissan Intelligent Key System?
You can also open and close the trunk, and can start the engine without having to insert the key, making departure seamless. By cutting out the trouble of putting in the key, there is no need to search for the key inside your bag or pocket.
Push any button on your key-less entry FOB remote ONCE. This should be done within 5 seconds of turning the key to ACC. You should notice your hazards flash again. If you have another remote to program proceed to step 5, otherwise turn the key off and remove it.
How do you put a Nissan in program mode?
Once you see the hazard lights flash twice, the car is now in program mode. Insert the key back into the ignition and turn it to ACC. Push any button on your key-less entry FOB remote ONCE. This should be done within 5 seconds of turning the key to ACC. You should notice your hazards flash again.