How do you change the clock spring on a Nissan?

Park your Nissan and set the parking brake. Remove the key from the ignition. Open the hood and disconnect the negative battery cable from the battery terminal. Wait 15 minutes. Your browser does not support video tag. Press the horn twice to discharge any residual current.

What does the owner’s manual for a Nissan Altima say?

1. Power windows (P. 2-43) 2. Windshield (P. 8-21) 3. Windshield wiper and washer switch (P. 2-27) 4. Engine hood (P. 3-24) 5. Tie down (P. 6-14) 6. Fog light switch (if so equipped) (P. 2-34) 7. Headlight and turn signal switch (P. 2-29) 8.

When did the 2012 Nissan Altima come out?

2012 NISSAN ALTIMA L32-D L32-D Printing : February 2012 (20) Publication No.: OM0E 0L32U2 Printed in U.S.A. OM2E 0L32U2 Welcome to the growing family of new NISSAN owners. This vehicle is delivered to you with confidence.

What does the Arrow mean on a Nissan Altima?

Ifyouseethissymbol,itmeans“Donotdothis” or“Do not let this happen.” If you see a symbol similar to these in an illustra- tion, it means the arrow points to the front of the vehicle. Arrows in an illustration that are similar to these indicate movement or action.

How to remove the steering wheel from a Nissan?

Remove the center bolt that secures the Nissan steering wheel to the steering column. Mark the steering wheel and column before you remove the steering wheel. Unplug steering wheel button wire harness. Watch the video on how to remove the Nissan steering wheel. Remove the plastic trim screws.

How to change the steering angle sensor on a Nissan?

How do you change the light bulbs on a Nissan?

Using a flat head screw driver or something similar, gently pry up the edges of the bezel at both the left and center air vents. Just push the flat head in between the plastic bezel and the padded dash and pry up gently…the retainer clips will pop and release the bezel. Do this all around the bezel until it’s popped out a little from the dash.

How does an airbag clock spring work on a car?

An airbag clock spring enables the connection of electrical wires from the airbag computer to the driver’s side airbag while the steering wheel is in motion. This clock spring also connects the horn and other switched controls located on the steering wheel such as radio and cruise controls. Symptoms…

Where does the clock spring go on a steering wheel?

4. Remove the Clock Spring: The clock spring sits over the center shaft of the steering column and is held in place by a set of small screws or plastic clips. Once the steering wheel has been removed do not rotate the clock spring upper plate.

What are the symptoms of a bad clock spring?

Symptoms of a bad clock spring include an airbag warning light on along with no horn operation. Also the radio or cruise controls may not work if they are mounted on the steering wheel. If you are doing the job yourself the part will cost between $55.00 and $110.00 (US) from Amazon depending on the manufacturer of the car.

How does an airbag clock spring work in a car?

An airbag clock spring is used to connect the steering wheel to other electrical devices such as the airbag safety system, radio volume and station selections, horn and cruise controls. This is done using a series of small wires wound between an upper and lower plate which is mounted between the steering column and the steering wheel.

When does a car clock spring go bad?

This is done using a series of small wires wound between an upper and lower plate which is mounted between the steering column and the steering wheel. This part can go bad when these wires become fatigued and break causing a short or open circuit.

What happens if you break the clock spring?

If repairs are being done which involve the removal of the steering wheel and the clock spring and it is mistreated by over extending the internal wires it will also break the clock spring. When this malfunction occurs it will cause the airbag warning light to come on and the system to shut down.

Navigation