Can a fork seal be replaced on a GS500?
Yesterday I carried out the fork seal replacement on my 2008 gs500. I just wanted to let you guys know that the “special tool” does not apply to the 08 model because the damper rod must be different to older models and is all round. The way we got around that was to use a rattle gun (impact wrench) while pulling on the fork tube.
How do you replace a fork seal on a motorcycle?
Use these steps to replace your fork seals. Prepare the motorcycle for maintenance. Loosen the 2 bolts that secure the fork legs to the frame and the caps upon each leg. Then loosen the brake caliper bolts and the whole front axle of the bike. Put the bike in gear and chock the rear wheel. Raise the front wheel off the ground as far as needed.
When to replace oil seals on a motorcycle?
Fork seals should be replaced as soon as leaking oil is noticed. If the seal is left unchanged, the oil could leak onto the brake pads and ruin your motorcycle or you could run out of oil completely and ruin your motorcycle. Use these steps to replace your fork seals. Prepare the motorcycle for maintenance.
How do you remove dust seal from Fork?
Wedge the dust seal from the fork leg. Find the fork seal itself. It is held into place by a clip within a groove. Pry the seal out carefully. Flush the area as you go to remove debris within the fork. Take the tube in 1 hand and the stanchion in the other. Use muscle to pull the 2 apart. You will see the seal coming out of hiding as you do this.
Yesterday I carried out the fork seal replacement on my 2008 gs500. I just wanted to let you guys know that the “special tool” does not apply to the 08 model because the damper rod must be different to older models and is all round. The way we got around that was to use a rattle gun (impact wrench) while pulling on the fork tube.
How do you replace oil seal on front fork?
Situate the clip and dust seal back onto the fork. Place the damping rod back inside. Pour new oil into the fork, measuring the height as necessary. Re-install the spring and screw on the fork cap. Tighten the bolts. Repeat the process on the other fork leg. Reassemble your motorcycle’s front end. How much oil goes in the front fork?
How to remove dust seal from fork leg?
1 Wedge the dust seal from the fork leg. 2 Find the fork seal itself. It is held into place by a clip within a groove. 3 Pry the seal out carefully. 4 Flush the area as you go to remove debris within the fork. 5 Take the tube in 1 hand and the stanchion in the other. Use muscle to pull the 2 apart.
Fork seals should be replaced as soon as leaking oil is noticed. If the seal is left unchanged, the oil could leak onto the brake pads and ruin your motorcycle or you could run out of oil completely and ruin your motorcycle. Use these steps to replace your fork seals. Prepare the motorcycle for maintenance.