Where is the oil tank drain plug located?
Position the catch pan under the drain plug, which is located at the bottom of the engine cases. Remove the oil tank drain with an Allen wrench. Inspect the drain plug O-ring for damage or wear. Allow the oil to drain fully. Install the drain plug. Torque the plug to factory specifications for your year and model.
How do you change drain plug on Harley Davidson?
*TIP* The OEM drain plug uses a hexhead wrench to remove it. Being located in a position that is difficult to reach and keep a firm grip on, the head is easily stripped. This plug has been replaced with an allen wrench bolt, much easier to keep an allen wrench firmly seated in the head and greater torque ability.
Where is the oil held in a Harley Davidson Low Rider?
Harley-Davidson Lowriders use a built-in oil pan instead of the traditional remote-mount type oil reservoir. The pan is cast into the bottom of the engine case, and the oil is held in with a special bolt with an o-ring seal. Engine temperatures vary widely in air-cooled engines, leading to oil breakdown.
How can I check the oil level on my Harley Davidson?
Stick the oil tank with the plug/dipstick to check the oil level. Test run the bike, and watch the drain plug and filter for leaks. Always use Harley-Davidson factory-authorized motor oil and filters. Check your service manual for the proper weight and amount of oil. Inspect the drain plug magnet for metal salt or shavings.
Where is the oil drain plug on a Dyna Glide?
Place a catch pan under the engine and remove the oil drain plug using a 5/8″ wrench or socket. Be sure to collect the drain plug O-ring, as well. Figure 2. Oil drain plug location (left side of bike).
Where is the oil drain on a Harley Davidson?
Locate the engine oil drain hose near the left rear frame rail, below the transmission unit. Pull the drain hose out of its retaining bracket, then remove the drain plug with a flat-head screwdriver. Alternatively, 1993 to 1998 Touring models use a crankcase drain plug, located under the front of the engine.
*TIP* The OEM drain plug uses a hexhead wrench to remove it. Being located in a position that is difficult to reach and keep a firm grip on, the head is easily stripped. This plug has been replaced with an allen wrench bolt, much easier to keep an allen wrench firmly seated in the head and greater torque ability.
Position the catch pan under the drain plug, which is located at the bottom of the engine cases. Remove the oil tank drain with an Allen wrench. Inspect the drain plug O-ring for damage or wear. Allow the oil to drain fully. Install the drain plug. Torque the plug to factory specifications for your year and model.