Where is the timing adjustment on a Honda Accord?
Locate the blue timing adjustment connector under the passenger’s side of the dash. There are two blue connectors. The one for the timing adjustment is the two-pin connector. Insert a jumper wire into the connector to connect the two terminals.
Where is the 18 degree mark on a Honda Accord?
On the 1989 Honda Accord, 18 degrees is the middle mark (painted red) of the three marks on the crankshaft pulley. The 18 degree mark should be centered in the timing pointer. Turn off engine and remove the paper clip from the timing connector and unclip the timing light from the battery and spark plug wire.
How do you set the timing on a Honda Civic?
How to Set the Timing on a 1999 Honda Civic 1.6L. Start the engine and allow it to warm up until the operating temperature is reached on the gauge in the instrument cluster. Turn the engine off. Locate the blue timing adjustment connector under the passenger’s side of the dash. There are two blue connectors.
Where is the ignition timing on a Honda?
The car must first be warmed up until the fan turns on. Timing marks are exposed by removing the rubber cap from the inspection window on the cylinder block, by the bell housing. Also, the ignition timing check connector must be jumped. It is located under the center of the dash. See the drawing below for its location.
How to check ignition timing on Honda Accord?
Align the pointer with the Red timing mark. When the job is done, tighten the distributor bolts to 16 ft. lbs. (22 N.m). and recheck timing. If it is all OK, remove the jumper from the ignition timing check connector. Reinstall the cap into the inspection window on the cylinder block.
How to Set the Timing on a 1999 Honda Civic 1.6L. Start the engine and allow it to warm up until the operating temperature is reached on the gauge in the instrument cluster. Turn the engine off. Locate the blue timing adjustment connector under the passenger’s side of the dash. There are two blue connectors.
On the 1989 Honda Accord, 18 degrees is the middle mark (painted red) of the three marks on the crankshaft pulley. The 18 degree mark should be centered in the timing pointer. Turn off engine and remove the paper clip from the timing connector and unclip the timing light from the battery and spark plug wire.
What’s the best way to adjust ignition timing?
To adjust timing, loosen the distributor hold-down bolts and turn distributor housing counter-clockwise to advance or clockwise to retard timing. Align the pointer with the Red timing mark.