How do you remove the seat on a Harley Davidson?
Harley seat removal is simple, but it is important to keep track of your hardware and store the seat in a safe place; away from anything sharp, or any chemicals/oils that can harm the seat. When you open your right side saddlebag lid, you will see the Phillips screw that secures the seat strap.
How do you remove the seat on a Harley Heritage Softail?
Reinstall the nylon washer, lower the rear of the seat onto the frame and tighten the Torx head bolt to secure the seat to the fender. Lift the loose end of the seat strap over and across the seat. Secure it in place by tightening the Torx head bolt into the strap bracket on the side of the fender.
When to remove the battery from a Harley Sportster?
In this quick demonstration of the Harley Sportster battery removal, you’ll learn how to remove your bike’s seat and side cover so you can check on the condition of your battery and its operating components. It is strongly recommended that you remove the negative cable of the battery first and replace it last when servicing your bike.
How do you attach a washer to a car seat?
Hold the seat at a slight angle with the front tipped downward. Slide the seat forward and slip the metal tab under the saddle into the catch tab on the frame. Reinstall the nylon washer, lower the rear of the seat onto the frame and tighten the Torx head bolt to secure the seat to the fender.
How do you remove a seat on a Harley Davidson?
To remove seat, first remove passenger seat buy unscrewing the rear retaining screwing and sliding the seat towards the rear of the bike to remove the locating slots from the front seat mounting fasteners. Next remove the front seat mounting fasteners and slide the seat rearwards to free the tang at the front of the seat.
How is the pillion seat installed on a Harley Davidson?
The pillion seat attaches with a single screw at the rear and engages to the drivers’ seat mounting screw at the front. To remove seat, first remove passenger seat buy unscrewing the rear retaining screwing and sliding the seat towards the rear of the bike to remove the locating slots from the front seat mounting fasteners.
Reinstall the nylon washer, lower the rear of the seat onto the frame and tighten the Torx head bolt to secure the seat to the fender. Lift the loose end of the seat strap over and across the seat. Secure it in place by tightening the Torx head bolt into the strap bracket on the side of the fender.
How do you install seat bolts on a Harley Davidson?
Slide retention nut over the tapered end of a cable tie so that the larger O.D. of nut rests on the cable tie strap eyelet or if using a piece of wire bend the bottom end of the wire to prevent the nut from falling off. Feed the cable tie or wire up through fender hole.
Where is the fuse box on a Harley Davidson?
I know the fuse box is under the seat of my 03 softail heritage, but where is the main fuse I believe it’s a 40a fuse. I’ve seen video saying to turn ignition on wait for light to turn off, then remove the main fuse and then the battery can be removed.
How do you remove a battery from a Harley Davidson?
At this point, you can access the battery ground cable; disconnect it, wrap it with electrical tape, and move on. Or, you can continue to remove the battery completely. Do this by simply removing the plastic ECM mounting plate/bracket.
What to do if your Harley wont turn on?
If you have any further questions, please contact Customer Service at 1-855-231-0653 at your earliest convenience, or chat with us on our site. We greatly appreciate your business! Hello, our 2016 harley roadster wont turn on. We just replaced the engine and it’s all put back together but nothing will turn on any idea?