Where is the throw out bearing on a Harley Davidson?
The throw out bearing — otherwise known as the pushrod bearing — is located just inside the transmission clutch release cover on the lower right-hand side of your Harley-Davidson. Replacement is rarely necessary, as it does not wear easily.
How do you replace bearings on a Harley Davidson?
Once the transmission trap door is removed from the case, you will be able to press out the old bearings and press in a new set. **Remember to always press on ONLY the outer race of the new bearings during assembly** Clean your gasket surfaces and evenly draw the transmission door back over the transmission shafts with the stock trap door hardware.
How do you change a Throwout bearing in a car?
When and if you are changing the clutch, change the throwout bearing also. Replacing a throwout bearing is simple and can be accomplished by any do-it-yourself mechanic. Drive the car up on the wheel ramps and set the parking break. Jack up the rear of the car using floor jack and place on jack stands.
How do you change a clutch on a Harley Davidson?
Press against the bearings outer race and on it’s numbered side. Pressing against the middle or the inner race of the bearing will damage the bearing. Lube the outside of the bearing and start it straight, by hand, if possible. A few light taps with a plastic or rubber hammer is ok for starting the bearing.
The throw out bearing — otherwise known as the pushrod bearing — is located just inside the transmission clutch release cover on the lower right-hand side of your Harley-Davidson. Replacement is rarely necessary, as it does not wear easily.
Once the transmission trap door is removed from the case, you will be able to press out the old bearings and press in a new set. **Remember to always press on ONLY the outer race of the new bearings during assembly** Clean your gasket surfaces and evenly draw the transmission door back over the transmission shafts with the stock trap door hardware.
Press against the bearings outer race and on it’s numbered side. Pressing against the middle or the inner race of the bearing will damage the bearing. Lube the outside of the bearing and start it straight, by hand, if possible. A few light taps with a plastic or rubber hammer is ok for starting the bearing.
Is it necessary to replace a throw out bearing?
Replacement is rarely necessary, as it does not wear easily. If, however, you decide your throw out bearing does require replacement, it is accessible with simple hand tools.