How much is a stator for a Harley-Davidson?
Compare with similar items
| This item Accel 152115 50 Amp 3-Phase Motorcycle Stator for Harley-Davidson | Cycle Electric Stator CE-9100 | |
|---|---|---|
| Customer Rating | 4.7 out of 5 stars (20) | 4.8 out of 5 stars (17) |
| Price | $25368 | $94.43$94.43 |
| Sold By | Midwest Traction | Longhorn Moto |
| Item Weight | 3.15 lbs | 2.00 lbs |
How to remove a Harley Davidson stator and rotor?
Mike demonstrates a full charging system test including ohms resistance between fields, ground continuity, AC voltage output, and of course DC voltage to the battery. Mike demonstrates Harley Davidson stator and rotor removal so we can replace it with a 50 amp upgrade. Follow along.
How do you replace a stator on a cable?
Loosen the four bolts holding the stator to the cases. Before you pull the stator off, tie a string to the end of the cable by the regulator. Pull the string through the hole in the cases as you remove the stator. Install the new stator and pull the new cable through with the string you left behind.
How to install a stator on a Harley Davidson Soft Tail?
Unplug the voltage regulator from the motorcycle’s wiring harness, then pull the voltage regulator away. Mount a new voltage regulator onto the engine, then place the ground wire terminal over the right mounting post. Screw the mounting nuts into place and tighten them to 100 inch-pounds. Plug the voltage regulator into the wiring harness.
Can a stator be replaced on a twin cam Harley Davidson?
In this video, Mike walks us through the process of a full charging system test, along with the removal of a complete charging system on a Twin Cam touring model. He demonstrates the stator replacement with a 50 amp upgrade. This upgrade will keep your battery up to snuff as the demands on the battery and charging system keep growing.
What should I know about a Harley Davidson stator replacement?
The Harley Davidson stator replacement and upgrade is being done with quality parts made in the USA. The unique design of Cycle Electric Inc. stators offer: Insulation able to withstand temperatures of 600° F to eliminate stator burn out. Better low speed output to reduce battery discharge at an idle.
How to test the rotor on a Harley Davidson?
Each of the following tests isolate the stator and rotor. If the AC Output test fails and Resistance Check and Stator IB Test pass, then the rotor is at fault (Pull primary covers and inspect rotor for damage). Unplug the regulator plug from the stator. Start motorcycle and change Voltmeter to AC volts.
How long does it take to change a stator?
I bet a good tech can do a stator change in less then 3 hours and a belt change would take 6 or 7 hours. If your belt has been properly maintained it should go over a 100,000 easily. To replace the drive belt is more then you are thinking. To change the stator you can cheat a bit sometimes and not take the clutch out.
How to replace the shifter on a Harley Davidson Sportster?
Remove the shifter and linkage by removing the pinch bolt and prying it off. Drain the primary oil and remove the primary cover. Some cover screws are longer than others, so keep track. If you forget, the manual shows which go where.