How do you adjust a motorcycle rear suspension?
To adjust the preload on your bike’s rear shock, you will need a C-spanner to loosen the top locking ring and spin it up the shock to gain access to the adjuster ring. If you want to increase preload so the spring has less travel and to make the bike feel stiffer, turn the adjuster ring clockwise.
How to adjust rear suspension on mountain bike?
Before you start make sure your rear shock is in ‘fully open’ mode (if you have a low-speed compression adjuster wind it fully in the [-] direction). Have your assistant support the bike on level ground as you climb on. Bounce firmly up and down to charge the negative spring and free up the travel.
Do you have to adjust compression damping on rear shocks?
Not all suspension forks or rear shocks have adjustable compression damping so this section may not be applicable to you. If your suspension does have adjustable compression damping, you don’t HAVE to adjust it if you feel it might be a bit beyond you at the moment. that’s fine. Go ride your bike.
What’s the best way to set up a suspension?
Apply the lube to a paper towel and then wipe onto the seals. Push the suspension through its travel several times and then wipe clean any excess. This will keep your suspension in a healthy state. Always consider a full service of the internals of your suspension after 80 to 150h or yearly.
How to set up your ski doo rmotion rear suspension?
Learn how to set up your rMotion rear suspension correctly. The rMotion rear suspension from Ski-Doo is the benchmark for comfort, capability and adjustability. While it performs extremely well right out of the box, making these two or three simple adjustments will ensure it performs its best for you and your riding style in nearly every condition.
How can I change the ride height of my suspension?
You can change front ride height by moving the forks in the triple clamps, and rear ride height can be altered by lengthening or shortening the shock. The first item to address for any good suspension setup is setting preload for static sag.
How to set up suspension on a dirt bike?
Setting Rider Sag Check the shock for smooth action and check the heim joints, and/or linkage bearings for excessive stiction and binding. Put the bike on a stand that allows the suspension to fully extend. Measure from the axle center vertically to a point on the chassis.
What do you need to know about suspension setup?
The first item to address for any good suspension setup is setting preload for static sag. Static sag is the amount your suspension compresses from full extension when you sit on the bike. We’ve covered how to measure and set sag a number of times, but a short recap is shown at the bottom of this article.
Which is the best rear suspension for a truck?
Coil-over 4-Link rear suspension provides the best ride for any classic truck. These kits attach directly to the stock frame rails. The adjustable axle brackets let you set ride height in one of three positions, and a bolt-in upper crossmember for coilovers is included. Works with Heidts CO-101 and CB-105 coilover shocks.