How do you reset the timing belt light?
To reset it, remove the lower right section of the dashboard by removing the 2 screws that hold on the fuel filler cover lever. Remove the screw and move it to the other hole. This toggles the timing light between being on for odd or even 100,000s of kms. When your light comes on again after another 100,000 km move it back to the original position.
How do you reset the belt on a landcruiser?
1. T-BELT MODE DISPLAY b) While pressing the trip switch, turn the ignition switch ON and hold it for 5 seconds. c) Release the trip switch, then press the switch again within 5 seconds. d) The digital display should change to T-belt mode. The initial display “15” (0,000km) is displayed (ie. 150,000km). 2. REWRITING REPLACEMENT VALUES
How do you change to T Belt mode?
1. T-BELT MODE DISPLAY b) While pressing the trip switch, turn the ignition switch ON and hold it for 5 seconds. c) Release the trip switch, then press the switch again within 5 seconds. d) The digital display should change to T-belt mode.
What to do when your belt light keeps coming on?
Belt light came on and bike went to limp mode. Checked the toggle switch in the cover and did the belt light reset procedure. Belt toggle switch was not tripped as it was still in on position. Still reset the light and switched the toggle switch back and forth a few times just to be on the safe side.
How to reset the T Belt warning light?
T-BELT WARNING RESET COMPLETION a) After setting the replacement setting value, hold the trip switch ON for more than 5 seconds then release the switch. b) Check that the display has now changed back to ODO and that the warning light has gone off when the engine is started.
1. T-BELT MODE DISPLAY b) While pressing the trip switch, turn the ignition switch ON and hold it for 5 seconds. c) Release the trip switch, then press the switch again within 5 seconds. d) The digital display should change to T-belt mode. The initial display “15” (0,000km) is displayed (ie. 150,000km). 2. REWRITING REPLACEMENT VALUES
1. T-BELT MODE DISPLAY b) While pressing the trip switch, turn the ignition switch ON and hold it for 5 seconds. c) Release the trip switch, then press the switch again within 5 seconds. d) The digital display should change to T-belt mode.
It came on this morning at 124,800km, I replaced it at 118,000km so need to reset it. There should be a little bung in the clear plastic on the front of the instrument cluster and in line with that on the face of the cluster is a pin. Remove the bung and push the pin to reset it. My warning light came on today at just over 120,000 miles.
What happens if you ignore the timing belt light?
If yoy continue to ignore the light, the timing belt will eventually fail, which will likely result in severe motor damage. Best not to take chances, get it replaced ASAP.
What do I do if my belt light is not turning off?
The switch you are trying to use to reset the Timing Belt counter is on the bottom left. Seen from the side it is clearly a ‘press to make’ electric switch. Here it is before being depressed: Total movement is about 2mm. So pressing the switch in (while the ignition is switched on) should reset the counter inside.
When does the T Belt Light Come On?
The T-Belt light will come on just past 150 000 km, whether you replaced the belt or not. 1. Switch ignition on and select “odo” 2. Switch ignition off