How do you change the slides on a hyfax?
I will explain the best I can the 2 ways to change your slides (hyfax) WITHOUT pulling the rear suspensions. Slide Method 1:Need to loosen the track by using a 17 mm and 15 mm wrench on the back axel (Pic 1 #35 & 24) to crack loose the tension on the wheels that in turn hold the adjusters tight.
What do I need to make a hyfax wheel?
Send us your center shock bell-crank and aluminum wheel collars (parts to send) and we will machine them to fit our custom oversized wheels. This kit also stops the track from rubbing on the bell-crank ears and shock eyelet especially when studded down the middle. All Models with Center Shock Bell Crank:
Can you extend the life of a hyfax wheel?
You can easily extend the life of your hyfax four fold. Our wheel kits are larger then your originals and are profiled to fit Yamaha’s rear suspension per model. Why wear over half of your hyfax away before your factory wheels start to carry any load.
Which is the best way to save hyfax?
Technique #3: Take a new set of hyfax and get your drill. You’ll need a 3/8″ bit and some strength cause you will be tired after doing two hyfax full length. Start at either end it don’t matter cause you are going full length with the pattern. Drill two holes side by side followed by one and repeat.
I will explain the best I can the 2 ways to change your slides (hyfax) WITHOUT pulling the rear suspensions. Slide Method 1:Need to loosen the track by using a 17 mm and 15 mm wrench on the back axel (Pic 1 #35 & 24) to crack loose the tension on the wheels that in turn hold the adjusters tight.
Is there a snow wheel kit for hyfax?
This marginal snow wheel kit saves the hyfax from being wore down at the arch of the rail where hyfax wear is greatest. You will spend less time and money replacing hyfax and achieve a higher top end speed.This kit includes 2 wheels with bearings, billet stand offs and hardware.
How to save space on a hyfax wheel?
Simply remove the plastic spacers that came with the new wheels and remove the plastic spacers from the old wheels and put those old spacers on the new wheels. This allowed the stock, round metal spacer to fit within the wheel and then back on the rail brackJust use the plastic spacers from the Yami and bolt them on.
What’s the best way to lube your hyfax?
Also if you come to an area with dirt or low snow the holes are filled with good snow, it will melt and continue to lube your hyfax and wash out the dirt and sand untill you can get to some good snow which should be soon.