Where is the choke on a 1969 Honda Trail bike?
First, the choke. The “up” position (lever pointing toward the back of the bike on the 1969-on machines) is “choked.” Flip it up. Make sure the “altitude compensator” is not pulled out if the bike is equipped with it. You may not need the choke at all on a day where the air is 75 degrees or higher. Turn the ignition on.
What does it mean when your car stalls at idle?
If the Engine Stalls at Idle Unless You Press the Accelerator IV. If the Engine Starts When Cold but Stops When Warm V. If the Engine Stalls Intermittently I. If Your Engine Stops Immediately After it Starts Your engine may stop as soon as you let the key return from the Start to the Run position.
Where is the Kill Switch on a Honda Trail bike?
If all else fails, there’s a red kill switch near your right thumb. Shift up through the gears as you would with any bike, but remember that there’s no clutch lever. Back off the gas, then just shift. Then open up the gas again. If you want to climb hills, stop the bike.
Can a bad idle control valve cause stalling?
3. Engine stalling The idle control valve, also commonly referred to as the idle air control valve, is an engine management component that is found in one form or another on the majority of road going vehicles.
What is the choke plate on a Honda lawn mower?
The dynamism of Hond a engine carburetors is set through the sophisticated technologies applied where the right mixture of air and fuel is required for a smooth engine run. A cold engine requires less air to get going than when it is warmed up. This sets in place the controllable restrictor known as the choke plate in Honda engines.
When do you need to open the choke on a Honda?
But once the engine is running for a few minutes, it should run fine with the choke fully open. The choke is needed because the fuel does not evaporate completely when the engine is cold. Only gas vapor burns. Liquid gas does not.
Can a Honda snowblower run with choke closed?
Engine would only run with choke closed. Before you remove the entire carb to clean and/or rebuild, simply clean the bowl, clean the MAIN jet, carefully use some carb cleaner and re-assemble. This video is short because this solution is simple, quick and pretty effective. Loading…
Can a Honda gcv190 run with no choke?
I am running 100% pure gas with no ethanol now. With choke on, it pretty much purrs. When choke goes off, it dies, sometimes within seconds. So based on reading online, the default answer seems to be a plugged jet in the carb. Well this is a brand new carb so I don’t think that can be it now.