How do you change the rocker on a Harley Davidson?
Set the tank on a flat stable surface in a well vented place. Remove the six Allen bolts and washers that connect the rocker cover to the rocker assembly. Begin with the front rocker box and work on one cylinder at a time. Remove the metal D-ring if your motorcycle is equipped with an Evolution engine.
Why does my Harley Davidson rocker arm tick?
Stop the annoying Harley rocker arm tick. The Harley Twin Cam motor has a gap between the rocker arm shaft and the bolt that is supposed to lock it. This gap allows the shaft to rotate and hit the bolt causing a tick.
When do you replace rocker box gaskets on a Harley?
The next versions, which lasted until 1990, were made of zinc and leaked the most. Subsequent versions were rubber. Removing rocker box covers to replace the gaskets is a straightforward process. Very experienced mechanics can do the job without removing the gas tank but less experienced mechanics should probably begin this job by remove the tank.
What are the rocker lockers on a Harley Davidson?
The Harley Twin Cam motor has a gap between the rocker arm shaft and the bolt that is supposed to lock it. This gap allows the shaft to rotate and hit the bolt causing a tick. The Rocker Lockers eliminate the gap, locking the shaft from turning and striking the bolt and eliminate that annoying tick so many TC owners witness.
How to install a lower rocker box on a Harley?
Mike Roen has the Harley cylinders in place and is now ready to put the lower Harley rocker box on. Your gaskets are labeled front and rear. Make sure to install correctly. Make sure to remove the old o-ring. Prep your bolts with some blue Loctite and put them in the correct allocation.
How to replace the lower rocker box on a Dyna Glide?
Place a new gasket on-top of the lower rocker box and install the new cover. Use the sequence mentioned in Step 2 to install the cover bolts. Tighten the rocker box cover to 15-18 ft-lbs. Install the spark plug. Install the retainer screws for each push rod. Figure 9. Rocker boxes assembled and installed. Chrome Rocker Box Install. w/ Pics.
The next versions, which lasted until 1990, were made of zinc and leaked the most. Subsequent versions were rubber. Removing rocker box covers to replace the gaskets is a straightforward process. Very experienced mechanics can do the job without removing the gas tank but less experienced mechanics should probably begin this job by remove the tank.