Where can I buy a new Harley Davidson dipstick?
For model fitment information, see the P&A retail catalog or the Parts and Accessories section of www.harley-davidson.com (English only). There are no service parts for the LCD assembly or dipstick. A replacement CR 2032 battery (Part No. 66373-06) is available for separate purchase for all oil temperature/level dipsticks.
What should the oil level be on a dipstick?
NOTE To help prevent failure of the electronics inside, the dipstick does not measure oil level when the oil temperature exceeds 138 °C (280 °F). Animated level bars display, along with the temperature (Figure 1, display 16), up to a maximum reading of 155 °C (310 °F). The high temperature does not damage the dipstick.
What should I do if my motorcycle dipstick is damaged?
If the small plug next to the battery has become dislodged from the receptacle, reconnect it. If a visible wire is damaged, a repair can be attempted. If no damage is visible, the dipstick is damaged internally and needs replacement. For oil level inspection at operating temperature: Run motorcycle until engine is at normal operating temperature.
Can a non-threaded dipstick be used on a LCD?
Non-threaded Dipstick: Lightly oil the O-ring on the new LCD dipstick. Install the dipstick so the display window is: Push the dipstick straight into the filler neck until it seats. with Bar and Shield logo on left (toward the rear). Threaded Dipstick: Lightly oil the O-ring. Screw dipstick into the transmission like the OE dipstick.
How do you change the dipstick on a Harley Davidson?
Remove the original equipment (OE) dipstick from the filler neck. Non-threaded Dipstick: Lightly oil the O-ring on the new LCD dipstick. Install the dipstick so the display window is: Push the dipstick straight into the filler neck until it seats. with Bar and Shield logo on left (toward the rear). Threaded Dipstick: Lightly oil the O-ring.
How do you change the battery on a Harley Davidson?
A Dipstick Service Kit (Part No. 91800066), which includes O-rings, screws and a replacement CR 2032 battery is available for certain models (see Table 1 and Figure 3 ). Remove the original equipment (OE) dipstick from the filler neck. Non-threaded Dipstick: Lightly oil the O-ring on the new LCD dipstick.
Non-threaded Dipstick: Lightly oil the O-ring on the new LCD dipstick. Install the dipstick so the display window is: Push the dipstick straight into the filler neck until it seats. with Bar and Shield logo on left (toward the rear). Threaded Dipstick: Lightly oil the O-ring. Screw dipstick into the transmission like the OE dipstick.
When the power level of the dipstick battery falls below 2.4 V the LED backlight is disabled, and the battery symbol (see Figure 2 ) begins to flash. To help prevent failure of the electronics inside, the dipstick does not measure oil level when the oil temperature exceeds 138 °C (280 °F).