How fast does a 50cc scooter run?
Engine Size For low-speed traffic throughout town, a 50cc scooter will suffice and reach up to 40-45 miles per hour. Alternatively, a 150cc scooter can reach speeds up to 60 mph. Scooters with a faster speed require more experience, so consider that as well.
What to do if your motor scooter won’t run?
You need to check that it too has a little 0.004 clearance to ensure your scooter is running to its optimal performance level. This video by Rouse Garage will show you the process on a 50cc scooter with a common engine layout, you may find your scooter has a slightly different layout.
When did my 50cc GY6 scooter start having problems?
I purchased it new in the crate in 2013 as a left over from the dealer. It is common for 50cc GY6 Scooters valves to need adjusting every so often. My scooter had about 500 miles on it when the trouble began. Within 3 mos. and 200 miles later, it was so bad that I started replacing parts.
Why does my rocketa scooter slowly stop running?
I have a 2011 Rocketa 49.3 GY6 139QMB and have replaced the carburetor, petcock valve, CDI, all of the vacuum lines, adjusted the air flow and gas until it idles perfect and then, when I take off, it makes it two blocks, bogs down and dies! It will continue doing this about 5 or 6 times and then start running good but not great.
Why does my scooter engine slowly stop running?
When the engine is cold and the valve adjustment is too tight, but not so tight as to keep the exhaust valve open, the engine will start. As the engine warms up and the valves and rocker arms expand due to heat, the valve is forced open and cannot close. You then have no compression and the engine stops running.
You need to check that it too has a little 0.004 clearance to ensure your scooter is running to its optimal performance level. This video by Rouse Garage will show you the process on a 50cc scooter with a common engine layout, you may find your scooter has a slightly different layout.
I purchased it new in the crate in 2013 as a left over from the dealer. It is common for 50cc GY6 Scooters valves to need adjusting every so often. My scooter had about 500 miles on it when the trouble began. Within 3 mos. and 200 miles later, it was so bad that I started replacing parts.
How to stop a scooter from losing power under acceleration?
– Start with adjusting the idle screw and fuel/air mix out two turns. – Start scooter and adjust idle screw to the point where it is at highest RPM without rear wheel rotating. – Adjust fuel/air mix screw until scooter accelerates without bogging?? I guess the next logical step is to clean out petrol tank and lines!! Click to expand… Bingo!
I have a 2011 Rocketa 49.3 GY6 139QMB and have replaced the carburetor, petcock valve, CDI, all of the vacuum lines, adjusted the air flow and gas until it idles perfect and then, when I take off, it makes it two blocks, bogs down and dies! It will continue doing this about 5 or 6 times and then start running good but not great.