How do you clean a Harley Davidson fuel tank?
Harley Fuel Tank Cleaning
- Start by draining the fuel tank of any remaining gas.
- Pre-clean the tank with a 1/2 gallon of gasoline.
- Fill 1/2 the tank with hot water.
- Drain the acid mixture into a proper container and dispose of properly (not down the drain or in the trash!).
How do you attach a fuel tank to a Dyna Glide?
Install the tank console and gauge cluster assembly. Connect all electrical harnesses before securing the console and tank trim to the fuel tank. Connect the fuel crossover line using a new length of fuel line if necessary. Re-connect the fuel gauge wiring harness. Attach the fuel supply line to the fuel tank.
Can a fuel pump be replaced on a Dyna Glide?
Dyna fuel pump assembly. Many owners opt to replace the fuel lines while the fuel pump assembly is removed from the tank. The fuel lines tend to become brittle with age and are prone to leaking. Depress the release tab to remove the fuel filter retaining clip.
How to remove fuel filter from Harley Davidson Dyna Glide?
Remove the (12) screws from the top plate. Lift the top plate up at an angle to allow the hard vent tube to clear the fuel tank. With the top plate away from the tank, depress the tab on the fuel pump wiring harness with a small screwdriver to release it from the plate. Set the plate and plate gasket aside. Figure 6. Tank top plate removal.
Where is the fuse on a Harley Davidson Dyna Glide?
Remove the fuse box cover located just below the seat on the left-hand side of the motorcycle. Locate and remove the fuel pump fuse. With the fuel pump fuse removed, crank the engine over. The engine may start as well as run for a few seconds before it runs out of fuel and dies.
Install the tank console and gauge cluster assembly. Connect all electrical harnesses before securing the console and tank trim to the fuel tank. Connect the fuel crossover line using a new length of fuel line if necessary. Re-connect the fuel gauge wiring harness. Attach the fuel supply line to the fuel tank.
Remove the fuse box cover located just below the seat on the left-hand side of the motorcycle. Locate and remove the fuel pump fuse. With the fuel pump fuse removed, crank the engine over. The engine may start as well as run for a few seconds before it runs out of fuel and dies.
How do you drain a fuel tank on a Harley Davidson?
Pinching the fuel line with a set of vice-grips to block the flow of fuel can prevent unwanted spills when disconnecting the crossover fuel line. Once the line is disconnected and aimed into a funnel, undo the vice-grips to allow fuel to drain. After draining the fuel, remove the tank console and gauge cluster assembly.
Are there any Harley fuel lines left on Amazon?
. Only 12 left in stock – order soon. . Only 12 left in stock – order soon. . Only 12 left in stock – order soon. . Only 16 left in stock – order soon. . Only 7 left in stock – order soon. . Only 7 left in stock – order soon. . Only 11 left in stock – order soon.