Where is the choke on a Briggs and Stratton?
Some Briggs & Stratton models have air cleaners that are held in place with a wing-nut instead of screws. Inspect the engine to locate the choke lever, also known as the choke arm.
How do you install choke control on a car?
2. Place the choke control cable under the intake manifold from the front of engine (front pull choke). Insert the cable bowden wire into the choke control (front or reverse pull). Then place choke cable under the cable clamp. 3. Position the choke control so it bottoms, then pull it back approximately 1/16″ (1.5 mm).
What are the symptoms of a too rich carburetor?
Too Rich. When a vehicle is running rich, the fuel-to-air ratio is off because the carburetor is delivering too much gasoline. Typical symptoms of a rich mixture are: Poor fuel economy. Sluggish acceleration. Choke not needed from cold starts. Sooty or black spark plugs.
Why does your motorcycle only run on choke?
Fuel goes bad after time, and the first circuit/jet to clog with varnished up fuel is the pilot jet. This circuit delivers fuel for idle, and has the smallest passages found in carburetors.
2. Place the choke control cable under the intake manifold from the front of engine (front pull choke). Insert the cable bowden wire into the choke control (front or reverse pull). Then place choke cable under the cable clamp. 3. Position the choke control so it bottoms, then pull it back approximately 1/16″ (1.5 mm).
When to move throttle control to slow or fast?
Move the application throttle control to the slow position, then to fast. Check the engine control to assure it stops against the high idle RPM stop bracket. NOTE: When the application throttle control lever is in the slow position the engine governor spring must be free of tension or pushing pressure. A non- free spring can affect the RPM.
Where is the throttle control on a car?
Loosen the throttle control cable clamp located on top of the intake manifold, or on the intake manifold bracket, located to the right on one of the manifold mounting bolts. 4. Position the application throttle control in the fast throttle position. Then move the throttle control back 3/16″ (4.75 mm).