What does suicide throttle mean on a bike?
Never ride such a bike – they call that a “suicide throttle” for a reason. It’s also a wise idea to get in the habit of checking now and again to see that your throttle isn’t affected when you turn the handlebars completely from side to side. The clutch cable is far sneakier and creeps into your perception as perceived clutch slippage.
What happens when the throttle position sensor fails?
The throttle position sensor can fail in several ways, all of which result in poor fuel economy at best, and performance limitations that may create safety hazard for you and other motorists at worst. This sensor can fail gradually, or all at once. In most cases, the Check Engine Light is illuminated if a TPS failure is detected.
How can you tell if your bike throttle cable is going bad?
The throttle cable normally lets you know it’s going bad by refusing to snap back the throttle grip when it is turned and released. Never ride such a bike – they call that a “suicide throttle” for a reason.
How is the throttle connected to the accelerator?
In the old days, there used to be a cable that was connected from the throttle to the accelerator. But now in the technological age, the car’s computer controls when the throttle opens and closes by the feedback it gets about the acceleration of the vehicle.
When to crank the throttle with the throttle fully open?
(When flooded, crank the engine with the throttle fully open to allow more air to reach the engine.) Valve not seating properly (valve bent, worn, or carbon accumulation on the seating surface.) You must be logged in to post a comment.
Never ride such a bike – they call that a “suicide throttle” for a reason. It’s also a wise idea to get in the habit of checking now and again to see that your throttle isn’t affected when you turn the handlebars completely from side to side. The clutch cable is far sneakier and creeps into your perception as perceived clutch slippage.
The throttle cable normally lets you know it’s going bad by refusing to snap back the throttle grip when it is turned and released. Never ride such a bike – they call that a “suicide throttle” for a reason.
What to do if you have a loose vacuum hose on your bike?
First, start simple and look for a loose or open vacuum hose. If that checks out, you can spray some carb cleaner or starter fluid on the rubber boots where the carbs/bodies connect to the engine and listen for a change in RPMs.