What kind of oil does a Yamaha Virago 250 take?
What you need to service the V Star 250. The manual suggests Yamalube 10W-40 or Yamalube 10W-50 (if you ride in heat over 100F/40C). You need 1.4L without changing the oil filter, or 1.6L with changing it, so one gallon/4L should be good for two changes. Tighten the oil drain bolt to 34 Nm (25 ft-lb).
How much oil does a 250 Virago take?
After you’re sure you’ve got enough oil in, screw the cap back on and you’re ready to go. The bike is meant to take 1.4L (0.36 gallons) but you might overfill the bike to 2L (0.52 gallons) if you don’t let the oil settle properly when checking the gauge.
How to change the oil in a Yamaha Virago 750?
Remove the three Allen-head bolts that secure the oil filter cover to the left side of the motor with an Allen key. Pull the retaining clamp and filter cover away from the motor. Remove and inspect the oil filter cover O-rings. Replace them if they are damaged in any way. Pull the oil filter out of the motor and place it in your oil catch basin.
Do you need a tuneup for a Yamaha Virago?
If your bike’s running strong and true, just change that oil a lot (and some of the other fluids now and then as well) and enjoy your career as a Virago rider. B ut there will always be a few folks who think they need a Yamaha Virago Tuneup, and maybe they do.
How do you change oil on a virago Fork?
Loosen the 10mm fork brace clamp nuts at the top of the fork and bleed the air out of the fork tubes if applicable. Using the 17mm allen wrench, the 17mm bolt, or 3/8″ bolt (slightly filed down to fit the fork cap) and clamped with vise grips unscrew the fork cap. It may not break free easily.
Where do you put the co probe on a Yamaha Virago?
Many Yamaha dealers have the equipment to do it. You’ll notice little belts in your headers. These are removed and the CO probe screwed in or inserted. Dealers may be reluctant to remove the plugs covering the pilot screws, but should be more willing to set your CO to where you tell them if the plugs are absent.
How to change oil on a Yamaha Virago?
A calibrated measuring cup that will hold up to 400cc of liquid. New oil – 2 pints of a motorcycle fork oil – I prefer Kal-Guard 10 weight. Place the bike on it’s center stand and prop it with the block so it remains tilted back and the front wheel is up. Cover or remove the gas tank and pop off the cover caps on the top of the fork tubes.
How do you replace a foot peg on a Yamaha mower?
Slowly pour oil into the motor, adding no more than 3.3 quarts to prevent overfilling the motor. Remove the funnel and replace the filler cap. Wipe away any oil that spilled onto the motor or frame with a shop towel and reinstall the left front foot peg. Refer to a Yamaha repair manual for detailed information regarding this process.
What kind of engine does a Yamaha Virago have?
As Yamaha’s first V-twin-powered cruiser motorcycle, the Virago has become a favorite for riders who prefer the bike’s classic lines and nimble handling. Although the Virago was available in a range of engine sizes, the 750cc model is the most commonly seen on the road today.
How do you put oil in a hatchback?
Fill the measuring cup to the recommended amount of oil (as stated in your owners manual being careful not to over fill) and raise one of the spacer tubes to act as a funnel. Pour the oil down the hatch. Do it again on the other side.