How fast does a Honda GX160 go?
Go Kart with 4-stroke Honda GX160 Engine with Maximum Speed of 70kph.
What happens if you change the governor on a Honda GX 160?
Improper adjustment of the engine’s governor will cause excessive revving at full throttle, which might cause damage to the engine. Adjusting the governor to the proper factory setting is an easy task with the proper tools. The Honda GX 160 is a horizontal-shaft engine, rated at 4.8 horsepower.
How to start a Honda gx160 GX200 engine?
Rotate the governor arm shaft as far as it will go in the same direction the governor arm moved to open the throttle. Tighten the nut on the governor arm. ④. Start the engine and allow it to warm up to normal operating temperature.
How does the Governor work on a Honda engine?
To control engine speed, a mechanical governor uses gears and flyweights inside the crankcase to detect changes in the load and adjusts the throttle accordingly. This closes the throttle, limiting the air-fuel released into the engine. When the engine load increases, the crankshaft spins more slowly. Click to see full answer
How do you adjust the valve clearance on a Honda gx160?
Insert a feeler gauge between the rocker arm and valve to measure valve clearance. ④. If adjustment is necessary, proceed as follows: a. Hold the rocker arm pivot and loosen the rocker arm pivot lock nut. b. Turn the rocker arm pivot to obtain the specified clearance. c. Retighten the rocker arm pivot lock nut while holding the rocker arm pivot.
How to adjust the engine on a Honda gx160?
GX120 GX160 GX200 Engine Adjustment Information ①. Remove the fuel tank. ②. Loosen the nut on the governor arm and move the governor arm to fully open the throttle. ③. Rotate the governor arm shaft as far as it will go in the same direction the governor arm moved to open the throttle. Tighten the nut on the governor arm. ④.
How does the Governor work on a Honda gc160?
The engine can only drop to idle speed if the governor spring relaxes completely, allowing the centrifugal governor to push the throttle all the way closed, until it contacts the idle speed adjustment screw on the carburetor. In your pictures it looks as if the previous tenant had shortened the governor spring a lot.
How many horsepower does a Honda gx160 T1 have?
The GX160 T1/K1 engine produced 6 PS (4.4 kW; 5.9 HP) at 4,000 rpm of maximum horsepower and 11.0 N·m (1.1 kg·m, 8.1 ft·lb) at 2,500 rpm of maximum torque.
What’s the problem with Honda gc160 pressure washer?
Hi Folks I have an 11 yr old Honda GC160 5.5 engine on a pressure washer. The top spring ( short one) on the Governor broke. I replaced it with the correct factory spring, however I can not seem to get the governor set correctly.