When to replace the release bearing on a clutch?
Always replace the throwout bearing whenever the clutch is removed for service. A faulty release bearing will make more noise when a load is applied, such as when the clutch pedal is depressed. Clutch forks take a lot of abuse. Inspect the entire clutch fork for signs of cracking, distress and metal fatigue.
How to adjust the release on an Eaton clutch?
7Apply lube to the release yoke fingers to reduce wear to the pads on the release bearing housing. 8Apply grease to the cross shaft bushings through the grease zerk on the side of the clutch housing. CAUTION: Failure to properly lubricate the bearing/ bushing will result in bearing and sleeve failures.
How to install an Eaton Lube release bearing?
1 1 3 4 5 6 7 8 2 Install second disc onto aligning tool. Follow the orientation instructions on the disc. Install two 7/6″ x 14 UNC x 5″ studs into upper mounting holes. Install assembled clutch. 3 8Position the release bearing so the orientation of the lube fitting is in the 4 O’clock position. Remove the aligning tool. 7
What causes a clutch shaft to become dislodged?
Input Shaft Wear (roughness) can reduce sleeve bushing life and cause it to become dislodged. Release Yoke Worn fingers can cause bushing wear and yoke interference when the Electronic Clutch Actuator is at the released position.
Do you need self adjusting release bearings on a clutch?
Today’s clutches require self adjusting release bearings. Finger Height Unmounted clutches may have significantly different appearances. Different manufacturers’ parts for the same application may have different appea rances.
How is the clutch set up on a 14.5 ” transmission?
FASTEN TRANSMISSION TO FLYWHEEL HOUSING Transmission installation and clutch set-up procedures are the same for the 14″ and 15.5″ clutch. 1. Put transmission in gear. Be sure new clutch brake has been installed. 2. Make sure that the yoke fingers remain in the up position until they are over the release bearing housing. 3.
What do you need to know about self adjusting clutches?
Self-Adjusting Clutches (SAC) are preset from the factory and require no modification. Crankshaft end play will cause release problems. Always inspect and diagnose adjacent systems for possible problems. Check us out on the web for more technical and diagnostic clutch information.
When do diaphragms need self aligning release bearings?
Self Adjusting Diaphragm Lever Self Aligning Release Bearings The bearing will self align within the first few cycles after installation. Today’s clutches require self adjusting release bearings.