How to replace the headlight on a Dodge Ram 1500?
1 Use the 10 mm socket wrench to unscrew the first of three 12 mm long 10 mm hex-head screws holding in the headlight assembly. 2 Unscrew the second screw located approximately 6 inches below the first. 3 Locate the third screw at the bottom left corner of the headlight assembly just behind the bumper and remove.
Where do you unscrew the headlight screws?
Use the 10 mm socket wrench to unscrew the first of three 12 mm long 10 mm hex-head screws holding in the headlight assembly. The screw is located just to the left of the headlight assembly. Unscrew the second screw located approximately 6 inches below the first.
How do you replace fog lights on a Dodge Ram?
These couldn’t be easier to replace. Simply reach up under the bumper, grab the bulb on the back of the housing, and give it a 1/4 twist counter-clockwise to pop it out. Pull the bulb straight out of the harness, and push the new one in. Put it back into the housing and twist 1/4 turn clockwise to lock it back into place. You are done! Figure 4.
How do you remove a headlight from a car?
Remove the headlight from the vehicle per the manufacturer’s instructions. In some vehicles, a screwdriver can be used to remove clips located along the edge of the engine compartment. In other vehicles, you must partially detach the bumper to access the headlight.
How to replace headlights 02-05 Dodge Ram 1500?
The experts at 1A Auto teach you how to replace the headlights on your 02-06 Dodge Ram. Note: DO NOT TOUCH the bulbs- the oil from your fingers will burn into the light and foul your bulb. Clean with rubbing alcohol and a soft cloth if the bulbs do get touched. Open up the hood.
Use the 10 mm socket wrench to unscrew the first of three 12 mm long 10 mm hex-head screws holding in the headlight assembly. The screw is located just to the left of the headlight assembly. Unscrew the second screw located approximately 6 inches below the first.
How do you remove a headlight wire from a car?
Locate the blue headlight wire. Use a flathead screwdriver to pry up one side of the clamping teeth and pull the connector off. Locate the green turn signal wire clamp. Use a flathead screwdriver to push in the tab on the side and pull off the connector.
What kind of lightbulb do I need to replace my headlight?
The replacement lightbulbs are by Sylvania Silverstar Ultra H11 for the low-beam headlight and Silverstar Ultra 9005 for the high-beam light. Want a great tool to help you with your YouTube videos?