What causes CV carburetor on Harley to slow down?
If there is a vacuum leak the gas will be drawn into the leak and cause the engine RPM to slow or fluctuate. DO NOT PERFORM THIS NEAR AN OPEN FLAME. Again it should be emphasized, the #1 cause of carburetor related problems on a Harley or other V-Twin motorcycle is VACUUM LEAKS. The CV carb is dependent upon vacuum to function properly.
What causes hesitation after a carburetor rebuild?
1) The #1 cause of hesitation and performance issues following a carburetor rebuild or install is VACUUM LEAKS. The importance of a perfect seal where the carburetor spigot press fits to the manifold boot seal is critical.
What makes a Harley Davidson run a little rich?
+1 on running a little richer, Harleys seem to run to lean from the factory. Unless your dumping to much fuel you should be fine. More information please. What is the build? CV or Mik carb? How is the carb currently jetted? What symptoms make you think she’s running rich? The A/F screw is for idle and transition from idle to pilot/slow circuit.
Where is idle mixture screw on Harley CV carburetor?
Locate the idle mixture screw on the bottom outlet side of the carburetor, in a passageway next to the float bowl. Turning the idle mixture screw in, or clockwise, will lean the idle mixture and turning it out, or counterclockwise, will enrich it.
1) The #1 cause of hesitation and performance issues following a carburetor rebuild or install is VACUUM LEAKS. The importance of a perfect seal where the carburetor spigot press fits to the manifold boot seal is critical.
Is it possible to tune a Harley Davidson carburetor?
Tuning your Harley Davidson carburetor is simpler than most think and can be performed with a few common tools. This simple procedure is a great Harley tech tip that applies to all Harley carbs from 1989 to present that use the CV style Harley Davidson carburetor.
What causes the carburetor on a Harley to slow down?
If there is a vacuum leak the gas will be drawn into the leak and cause the engine RPM to slow or fluctuate. DO NOT PERFORM THIS NEAR AN OPEN FLAME. Again it should be emphasized, the #1 cause of carburetor related problems on a Harley or other V-Twin motorcycle is VACUUM LEAKS.
Locate the idle mixture screw on the bottom outlet side of the carburetor, in a passageway next to the float bowl. Turning the idle mixture screw in, or clockwise, will lean the idle mixture and turning it out, or counterclockwise, will enrich it.