Where are the retaining clips on my brake pads?
Removal of Retaining Clips and Old Brake Pads Retaining spring clips are mostly found on the caliper that’s attached to the brake discs. So, identify the clips and detach it from the caliper pins that hold the pads in place.
Can a retaining pin be removed from a caliper?
Some caliper designs use a a retaining pin to secure the pads. If one is present remove it. This design uses a cotter pin. Bend the ends straight to remove. Some designs have a pin clip. If so, remove it before removing the retaining pin. Some pads systems use a spring that is removed with the pads. Note that new pads come with a new spring.
How do you remove brake pads from a disc?
Remove the spring first from the top, then the pads can be removed from the bottom. Before installing the new pads, we need to fully retract the pistons. This makes room for the extra pad material on the new pads. For hydraulic calipers, press the pistons back into the caliper body.
Where are the retaining spring clips on a car?
Retaining spring clips are mostly found on the caliper that’s attached to the brake discs. So, identify the clips and detach it from the caliper pins that hold the pads in place. Once that’s done, you’d have to remove the pins from the loop, why?
How to replace rear brake pads and rotors?
Step 5 – Using a pair of dikes remove the rotor retainer clip which is used in initial assembly and will not be reinstalled. Step 6 – Next, use a socket to remove both upper and lower caliper mounting bolts. Use a wrench if necessary to secure the slide.
How do you install a retaining pin on a disc brake pad?
Install any retaining pin. On systems with a cotter pin, make sure to give the cotter pin a good bend to prevent it from sliding out. On systems with a threaded retaining pin, be aware of any torque specification from the manufacturer. In general, the pin should be snugged to the caliper body.
Some caliper designs use a a retaining pin to secure the pads. If one is present remove it. This design uses a cotter pin. Bend the ends straight to remove. Some designs have a pin clip. If so, remove it before removing the retaining pin. Some pads systems use a spring that is removed with the pads. Note that new pads come with a new spring.
How do you put new disc brakes on a car?
For mechanical disc brakes, after installing new pads you will need to align your calipers. For hydraulic disc brakes, pump the lever to move the pistons and pads back to the working position. Pump until you feel the pads firmly contacting the rotor. Spin the wheel and inspect the pads for alignment. If there is no rubbing, you are done.