How do you change a brake light on a 2015 Hyundai Elantra?

How do you change a brake light on a 2015 Hyundai Elantra?

Procedure

1. Open trunk.
2. Remove the cover and access the back of the tail light assembly.
3. Disconnect the electrical wire.
4. Remove the brake light socket by turning it counterclockwise.
5. Remove the brake light bulb from the socket by pulling it out.
6. Install the new brake light bulb into the socket.

How do you replace tail light on Acura MDX?

With both screws removed, use a soft wedge (preferably one made of plastic, though a covered flathead screwdriver should suffice) in between the assembly and the body of the car; wedge the assembly loose. Now pull the tail light assembly out.

How do you replace a tail light assembly?

Replace with new assembly by inserting the light bulbs in to their appropriately assigned holes; twist to secure in place. Figure 4. Remove each bulb from the assembly. Once all of the bulbs are in place, move the assembly back into its location within the body of the vehicle. Line the assembly hole up so the screw holes match up.

Is it illegal to drive a broken tail light?

Whether it’s a blown bulb, faulty light, or cracked assembly, a broken tail light is both annoying to deal with and illegal to drive. Fortunately, Acura made it super simple to fix in the MDX. This article applies to the Acura MDX. In need of a new tail light assembly for your Acura MDX?

Where are the grommet caps on an Acura MDX?

With the trunk open, locate the two grommet caps located next to the tail light assembly, on the interior portion. Pop them out with a flathead screwdriver.

With both screws removed, use a soft wedge (preferably one made of plastic, though a covered flathead screwdriver should suffice) in between the assembly and the body of the car; wedge the assembly loose. Now pull the tail light assembly out.

Replace with new assembly by inserting the light bulbs in to their appropriately assigned holes; twist to secure in place. Figure 4. Remove each bulb from the assembly. Once all of the bulbs are in place, move the assembly back into its location within the body of the vehicle. Line the assembly hole up so the screw holes match up.

Whether it’s a blown bulb, faulty light, or cracked assembly, a broken tail light is both annoying to deal with and illegal to drive. Fortunately, Acura made it super simple to fix in the MDX. This article applies to the Acura MDX. In need of a new tail light assembly for your Acura MDX?

With the trunk open, locate the two grommet caps located next to the tail light assembly, on the interior portion. Pop them out with a flathead screwdriver.