How do you change a turn signal on a Harley Davidson?
Apply cleaner to a rag or shop towel and remove all the debris before reinstalling back on the bike. Repeat this process for all other turn signals. Check all turn signals for proper operation. Turn the ignition key to the ON position, switch on the signals and check the left, right, front as well as back for proper operation.
How do you remove the rear fender on a Harley Davidson?
Evenly loosen all of the Harley rear fender strut hardware then remove the two forward most strut bolts that screw directly into the motorcycle’s frame. Next, remove the strut bolt that is secured through the rear frame horn.
How do you replace turn signal light bulbs?
But error-free LED bulbs are designed to communicate with your vehicle’s CAN Bus computer system and prevent error messages. Using a Phillips screwdriver, remove the screws attaching your turn signal lens from the housing.
How do you change the light bulb on a Harley Davidson?
Align the bumps on the bulb with the grooves in the socket, not that one bump is offset lower than the other. Gently press the bulb into the socket and turn clockwise until it is snugly held in place by the grooves.
Apply cleaner to a rag or shop towel and remove all the debris before reinstalling back on the bike. Repeat this process for all other turn signals. Check all turn signals for proper operation. Turn the ignition key to the ON position, switch on the signals and check the left, right, front as well as back for proper operation.
But error-free LED bulbs are designed to communicate with your vehicle’s CAN Bus computer system and prevent error messages. Using a Phillips screwdriver, remove the screws attaching your turn signal lens from the housing.
Align the bumps on the bulb with the grooves in the socket, not that one bump is offset lower than the other. Gently press the bulb into the socket and turn clockwise until it is snugly held in place by the grooves.
What should I use to clean my turn signal?
A window cleaner or just soap and water will do for cleaning the turn signal lens. Apply cleaner to a rag or shop towel and remove all the debris before reinstalling back on the bike. Repeat this process for all other turn signals. Check all turn signals for proper operation.