How can I test the new Geo Tracker?
Crank the Geo Tracker and depress the brake pedal all the way to the floor and then back up again three times. This will position the new brake pads the proper distance from the brake rotor. Test drive the tracker to check out the new brake pads.
How do you change the brake pads on a Geo Tracker?
Go over the lug nuts twice to ensure that each nut is tightly secured to each wheel. Crank the Geo Tracker and depress the brake pedal all the way to the floor and then back up again three times. This will position the new brake pads the proper distance from the brake rotor.
How do I reset the brake warning light?
To reset the ABS brake warning light, manually, the key needs to be in the ignition switch and turned forward to the run position, which is located directly before the start position. Loosen the negative cable connection on the battery post with a 10 millimeter box wrench, and remove it.
How to adjust the brake light switch on a car?
1 Adjust Brake Light Switch (if there is room.) 2 Brake Light Fuse 3 Brake Light Stopper / Bumper Pad 4 Brake Light Wire Harness More …
Crank the Geo Tracker and depress the brake pedal all the way to the floor and then back up again three times. This will position the new brake pads the proper distance from the brake rotor. Test drive the tracker to check out the new brake pads.
Go over the lug nuts twice to ensure that each nut is tightly secured to each wheel. Crank the Geo Tracker and depress the brake pedal all the way to the floor and then back up again three times. This will position the new brake pads the proper distance from the brake rotor.
What to do when your brake lights won’t turn off?
If your brake lights won’t turn off, here’s a quick fix for your problem. Brake light sensors are an inexpensive part that may need adjusted, as you may find out when your lights won’t turn off. Loading…
How do you remove lug nuts from a tracker?
Walk around the Tracker to make sure the ground or surface is level underneath the car. Then, loosen each lug nut from the front wheels with a lug nut tool such as a tire tool or a lug wrench. Do not remove the lug nuts. Slide the floor jack under the front end of the Tracker and position the jack under a safe jacking point.