How do you change the oil on a Harley Davidson?
Evidence of engine wear is found by this presence of this metal shaving. Now we will move to the other side of the bike to remove the filter. The Harley filter wrench is just the size to fit between the shift linkage and the filter itself. Also,there is an electrical wire just below the filter, Be careful not to mangle the wire.
How do you change drain plug on Harley Davidson?
*TIP* The OEM drain plug uses a hexhead wrench to remove it. Being located in a position that is difficult to reach and keep a firm grip on, the head is easily stripped. This plug has been replaced with an allen wrench bolt, much easier to keep an allen wrench firmly seated in the head and greater torque ability.
Can you get after market oil on a Harley?
Read the manual. Buy genuine Harley oil and filters. There are after market products and they are cheaper, but they are not recommended. You are saving about $30.00 in labor, be happy with that. Even after combing the area for dog poop, you should put down a piece of cardboard or a blanket.
Is there a wrench for a Harley Davidson filter?
The Harley filter wrench is just the size to fit between the shift linkage and the filter itself. Also,there is an electrical wire just below the filter, Be careful not to mangle the wire. You will only be able to make small turns, the filter is not really torqued on, it is just a difficult space to work in.
How do you change the oil in a Harley Davidson?
Drain the engine oil into an oil pan. Replace the drain plug’s O-ring, then screw it into place after the oil has drained. Tighten the drain plug to 18 foot-pounds with a torque wrench. Unscrew the oil filter from the front of the engine, using an oil filter wrench. Drain any oil trapped within the filter housing into your oil pan.
Where is the oil drain on a Harley Davidson?
Locate the engine oil drain hose near the left rear frame rail, below the transmission unit. Pull the drain hose out of its retaining bracket, then remove the drain plug with a flat-head screwdriver. Alternatively, 1993 to 1998 Touring models use a crankcase drain plug, located under the front of the engine.
How to change the three oil compartments on the Harley?
How to Change the Three Oil Compartments on the Harley Davidson Twin Cam Motorcycle. 1 Step 1. Warm up your Harley-Davidson motorcycle to bring its fluids to operating temperature. Start the motor and let it idle for at least 3 minutes, 2 Step 2. 3 Step 3. 4 Step 4. 5 Step 5.