What should I replace the ignition coil on my petrol generator?
This replacement ignition coil is for our petrol generator model numbers: SPG2200 and SPG3200. Replacement Ignition coil with HT lead and spark plug cap. Built with SGS quality parts for long life. Conducting metals on ignition coils can rust due to the metal components required a spark.
How many spark plugs does an ignition coil need?
In these systems, two spark plugs are supplied with high voltage by each single ignition coil. Since the ignition coil generates two sparks simultaneously, one spark plug has to be in the working cycle of the cylinder and the other offset by 360° in the ejection cycle.
What are the specifications for ignition coil resistance?
That is the “secondary winding” of the coil (transformer). The DC resistance value is within the specifications. Between the two connectors on the bottom .5 to .6 ohm That is the “primary winding” of the coil (transformer) and is also within the DC resistance value specifiactions. Do these measurements make any sense? Mike Yes they do.
How to check the actuation of the ignition coil?
Check the primary actuation of the cylinder 3 ignition coil 1 Remove the connector from the ignition coil 2 Connect the oscilloscope or diagnostic tester to the measurement module 3 Connect the probe tips to PIN 1 and PIN 2 using the two-pin connector. 4 Detach the plug connectors from the injection valves. 5 Start the engine
What does the ignition coil do in a two stroke engine?
The ignition coil or module for a two-stroke engine regulates the ignition power, and converts it to charging electricity for the battery system.
How can I test if my ignition coil still works?
Testing such units involves using a few electrical tools to gauge if the part still works, since most modules and coils are sealed with no serviceable parts. Disconnect the spark plug cap from the spark plug. Carefully remove the plug wire to the ignition coil from its hooks that keep it in place on the engine.
How to test ignition module of two stroke engine?
Attach the ends of a multimeter to the coil connections for input and to ground, testing electrical resistance in the unit. Replace the coil unit with a new one, if the reading shows as infinity or zero. This means that there is no resistance the unit is burned out. Take the good unit, or a new coil and reconnect it to the engine bracket.
Can you change the spark plug on a generator?
DO NOT make any adjustments to the generator without first stopping the engine and disconnecting the spark plug wire. Burns from hot parts — let the engine cool completely before touching hot parts.