How do you change a Softail starter on a Harley Davidson?
Let the tank hang from the drain hose and put some rags on the pipes to avoid scratches . It’s easier to get to the rear tank bolts if you drop the shield in front of the rear tire . Do a search on Softail starters cause there’s more threads about how it’s done .
What kind of starter does a 1998 Softail have?
Harley-Davison equipped the 1998 Softail Custom models with a Japanese made Nippon-Denso type starter. A common case houses the starter and starter solenoid, which prevents the replacement of the starter or the solenoid independent of each other.
Do you have to remove the clutch to change the starter?
Yes , you don’t have to remove the whole clutch / comp. sprocket assy. . Just remove the clutch retainer nut and slide the clutch out on the shaft far enough to get the starter drive assy. pulled out . You’re just doing the starter not the whole dang inner primary unless ya got leaks , then this is the time to go at them too .
How long does it take to replace a Softail Deuce?
02 Softail Deuce Starter Replacement in under 7 minutes. – YouTube If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations.
Let the tank hang from the drain hose and put some rags on the pipes to avoid scratches . It’s easier to get to the rear tank bolts if you drop the shield in front of the rear tire . Do a search on Softail starters cause there’s more threads about how it’s done .
Where is the starter relay on a 1986 Softail?
Hello, all! Can someone please tell me where my bike’s starter relay is located? Some have said it’s back by the battery compartment, others have said it’s between the fuel tanks the only stuff I saw between the fuel tanks were mainly a bunch of wires…..my bike is a 1986 Heritage Softail (1340cc Evo).
Yes , you don’t have to remove the whole clutch / comp. sprocket assy. . Just remove the clutch retainer nut and slide the clutch out on the shaft far enough to get the starter drive assy. pulled out . You’re just doing the starter not the whole dang inner primary unless ya got leaks , then this is the time to go at them too .
02 Softail Deuce Starter Replacement in under 7 minutes. – YouTube If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations.
How do you clear diagnostic code on Harley Davidson Softail?
Press and hold the odometer button to clear the code, and then shut off the ignition to exit the menu. Repeat the process to check the other systems. For 2014 and later models, hold the odometer button down on the lift grip. Move the ignition switch to the ignition position.
Can you remove the starter on a 5 speed Harley?
On 5 speed models, the outer primary cover needs to be removed in order to release the Harley starter shaft and bendix gear. This means, not only more time but also, an outer primary gasket, derby gasket, starter bolt lock washer, and primary oil. Here, Mike demonstrates starter removal on a Touring model.
How to check DTC’s on a Harley Davidson Softail?
Press and hold the mute/power button, and then turn the ignition switch to accessories. Keep the mute button held as the system starts up and for three seconds after the warning screen appears. Press the accept option on the touchscreen, then select “DTC’s.” Any active codes will be displayed at this time.
How do you get the tank out of a Harley Davidson?
Use a long screwdriver to pry the harness up high enough to slip the tank out the right side . Let the tank hang from the drain hose and put some rags on the pipes to avoid scratches . It’s easier to get to the rear tank bolts if you drop the shield in front of the rear tire .
How do you replace an oil burner tank?
Close the tank bottom drain valve, tap on it to be sure it’s shut, and with considerable caution, loosen and then at the oil tank, remove the existing bottom-feed oil tank line to the oil burner.
How do you remove the oil tank on a Harley?
Cut the factory squeeze clamps from the feed, return, and vent lines at the tank. Then, carefully pull the oil lines off of the oil tank. It is ideal to have rubber plugs ready in anticipation for residual oil. At this point, you can also reinstall the oil drain line plug. Remove two nylock nuts from the lower front mounting points.
Why do I need to remove my Softail oil tank?
In this video we take a look at Harley Evolution Softail oil tank removal. There are a number of reasons why you may need to remove your oil tank. You may want to have your tank painted or powder coated. You may have a damaged tank that needs to be replaced. You may need better access to your starter motor.