How do you kickstart a Yamaha Blaster?
Turn the gas on. Hit the switch to run. Then I slowly push down the kick start with my foot till I feel the piston start to come up on the compression stroke. I let the kicker return then give it a good kick.
Do Yamaha blasters have a battery?
nope no battery on a blaster just a kicker. i dont think its possible to mount one up, there is no system to support it, alternator, soloniods, there is no spot for a starter to mount.
Why is my Yamaha Blaster not getting spark?
make sure your t.o.r.s.(throttle override system) wires are connected to your t.o.r.s. on top of your carb or if you dont have a t.o.r.s. on there then splice the two wires together or you will not get constant spark,sometimes you’ll get spark and sometimes you wont,if thats not the problem then make sure your ignition …
Is the Yamaha Blaster reliable?
They are a fun reliable machine. Trails they do great on. Light, nimble.
How do you remove a kick start shaft?
Simple Kickstarter Removal – Pro Wrenching Secrets – Dirt Rider Magazine
- First loosen the bolt holding the kickstarter, but don’t remove it.
- Now fold open the lever as if you were going to kickstart the bike.
- Slowly finish removing the bolt and allow it to lift the starter off the splined shaft.
How does a motorcycle Kickstarter work?
The kickstarter itself is a lever that is connected to the engine. This lever is manually pushed down using the foot. When the kick start is not in use, it is stowed away and is flush with the bike. But to use the kick start, it’s a matter of swiveling it out so that you can put your foot on the lever itself.
How long will a Yamaha Blaster last?
If your top end is only lasting 20-30 hours,its time to get a different machinist,or stop working on your blaster and sell it,then go find a new hobby. This is very true! With the proper tolerances, jetting, and good oil, a Blaster engine will last for years with no problems.
Why does my two stroke engine not start?
(1) That you’ve flooded the engine by trying to start it, or that the lower end is loaded up (because you left the gas petcock on). (2) That there is no spark (thus, the plug is wet because the plug never ignited the fuel).
Can you put a kick start engine back together without oil?
Always put it back together fully without any oil just incase you have done it incorrectly and have to drain the oil again. Once back together, disconnect the spark plug lead and crank engine over manually to test, then once happy top up with 650ml of oil (your choice).
What to do when spark plug wont start?
If you suspect the spark plug cap, pull the lead wire out of the cap and look at the end of the wire. If the core wire is not visible or looks burned, cut 1/4-inch off the end of the wire and reinsert it into the spark plug cap (using the proper procedure, either prong or thread-in lead).
Why does my bike not start when I start it?
Your bike relies on the vacuum created by the piston and rings to suck fuel and air into the motor. If you’ve raced your bike nonstop for six months and it suddenly refuses to start, it’s because the piston and rings have become so loose they don’t seal against the cylinder tightly enough to create suction. The solution to this problem is easy.