What do points do in a distributor?
The points function as an on/off switch to supply voltage to the ignition coil. When closed, current flows to the coil. When open, current is interrupted. As the distributor shaft turns, the cam also turns.
Which is the best electronic ignition conversion kit?
Three different electronic ignition conversion kits are available, each with the ability to remove all of the mechanical variances and wear expected from breaker point systems. The original Ignitor Module is ideal for restorations while the Ignitor II provides increase starting voltage with adaptive dwell control.
How does the ignitor 2 electronic ignition work?
The Ignitor II units sense the current coil level and use a powerful micro-controller to adjust the dwell. The Ignitor III Electronic Ignitionis designed for the serious performance enthusiast who demands serious power. You’ll experience 5 times more spark energy than a typical points system.
Is the Hot Spark electronic ignition conversion kit maintenance free?
With points, the timing will drift; power and fuel economy will suffer. The Hot-Spark electronic ignition conversion kit delivers a strong spark every time and is maintenance-free. You’ll notice quicker starts, more top end power and a little gas mileage boost. Simple to Install. Advantages of the Hot-Spark electronic ignition conversion kit:
How to install Dyna ” s ” electronic ignition kit?
DYNA “S” Electronic Ignition Kit – Dual Fire VT Part No. 32-7778 & 32-0801 (Includes Coil) This is a custom application and rider safety depends on proper installation. This product should only be installed by a knowledgeable and trained motorcycle technician. V-Twin Mfg. accepts no responsibility for improper installation. V-Twin MFG.
We’ve got all the top brands, including the PerTronix Ignitor kits, Mallory E-Spark conversion kits, Crane points-to-electronic ignition conversion kits, and more. Go electronic today! Select your preferred location and we’ll note which parts are ready to be picked up TODAY.
How does single fire ignition work on a Harley Davidson?
The single fire ignition uses separate coil windings and electronics to fire each spark plug independently. Spark firing occurs only on the compression stroke. Conversion of older carbureted Harley-Davidson® engines to single fire is highly recommended. There is no downside to single fire, other than the cost of the conversion.
How does a Mallory Unilite dual fire ignition work?
VT No: 32-5119 Mallory unilite breakerless electronic ignition is a dual fire system. Points are replaced with the E-spark module that comes with a photo coupler a signal processor and a power switch. Every time the shutter wheel stops the infrared light from reaching the photo coupler the electronic circuit energizes the ignition coil.
What kind of coils do I need for a programmable ignition system?
Single plug: use Dynatek DC6-1 or a coil with 2.5 – 3.5 ohms resistance. Dual plug: use two DC2-1 coils wired in series(equals 3 ohms). 1. Remove the stock ignition module. Remove the outer and inner covers on the cam position sensor. Mark the engine case near the middle of the sensor. Remove the cam position sensor.