How long does it take to replace a Softail starter?
02 Softail Deuce Starter Replacement in under 7 minutes. – YouTube You are supposed to get the oil tank off without removing the rear tire but I was going to replace a valve stem too. that is in a separate video.
How do you remove a starter from a car?
Pull the bolts and end-cover from the starter. Loosen the starter mounting bolts with an Allen driver and ratchet. Lift the starter assembly from the engine. Remove the starter terminal nut with a wrench and pull the starter solenoid wires from the terminal stud. Pull the starter through the right side of the vehicle
How do you remove a lock washer from a car starter?
Loosen the jackshaft bolt with a wrench and pull the bolt and the lock washer out of the jackshaft. Remove the bolts from the chrome end-cover with a wrench. Pull the bolts and end-cover from the starter.
How can I Stop my starter from rotating?
Grab the pinion gear with a clean shop rag to prevent it from rotating. Loosen the jackshaft bolt with a wrench and pull the bolt and the lock washer out of the jackshaft. Remove the bolts from the chrome end-cover with a wrench. Pull the bolts and end-cover from the starter. Loosen the starter mounting bolts with an Allen driver and ratchet.
How do you remove a starter from a V-twin?
From right side of motorcycle, remove starter front mounting screw with lockwasher. Remove rear mounting screw with lockwasher (and battery negative cable ring terminal). Remove Keps nut from stud of bracket tab and remove exhaust support bracket. Pull back rubber boot and remove flange nut from starter post.
02 Softail Deuce Starter Replacement in under 7 minutes. – YouTube You are supposed to get the oil tank off without removing the rear tire but I was going to replace a valve stem too. that is in a separate video.
How do you remove a starter from a motorcycle?
Bend tab on lockplate away from head of jackshaft bolt . (This is on the upper right side inside the primary chaincase) Holding pinion gear to prevent rotation, remove the jackshaft bolt with lockplate and thrust washer. From right side of motorcycle, remove starter front mounting screw with lockwasher.
Can a starter be replaced on a Harley Davidson?
For safety purposes, disconnect the battery prior to removing the starter. While the starter can often be replaced with the battery and battery tray in place, Harley recommends they be removed for additional working room. Remove the seat, typically with just a thumb turn screw at the back of it.