How do you change a license plate light on a Toyota Corolla?
How to Replace Toyota Corolla License Plate Light Bulb
- Open the trunk and locate the clips that hold the interior trim panel in place.
- Disconnect the license plate light electric connector.
- Turn the bulb socket a quarter turn counterclockwise and remove it from the assembly.
How to change the light bulb in a Toyota Corolla?
1 Open the trunk lid and remove the trunk panel cover clips. To prevent damage to the vehicle, cover the tip of the screwdriver with a rag. 2 Partly remove the trunk panel cover and turn the bulb base counterclockwise. 3 Remove the light bulb.
How do you replace the light bulb on a license plate?
Remove the license plate light cover retaining screws using a screwdriver. Remove the license plate light cover. Note: You may need to use a small screwdriver to pry the cover off. Step 4: Remove the bulb. Remove the bulb from its retainer. Step 1: Install the new bulb.
How do you change the light bulb on a Toyota Camry?
Replacing the license plate bulb on a Vehicles is simple. Open the trunk to the Toyota Camry. Remove the interior trunk liner from the back of the vehicle. Use a Phillips screwdriver to twist the small center screw from the middle of the plastic fastener.
What to do if your license plate light has failed?
The license plate light is located right above the plate. Step 2: Determine which bulb has failed. Park your vehicle and set the emergency brake. Turn the ignition to the Accessory position and turn on the driving lights. Walk around the vehicle to determine which license plate bulb has failed. Step 3: Remove the license plate light cover.
How do I change the rear number plate light?
Installing the bulb
- Firstly, locate your number plate lights.
- You should be able to remove the light cover with a Phillips head screwdriver.
- Remove the old bulbs.
- Insert the new bulb.
- Place the cover back on and screw it in place.
- Turn on your car and all lights to make sure your new light is working.
How do you remove the rear license plate light?
Look for the lights above your license plate near the latch that opens your trunk. Locate the screws holding the covers against your vehicle and use a screwdriver to turn them counterclockwise. Once you have the screws loose, pull the covers off of your vehicle to expose the light bulbs underneath them.
Are Led number plates legal?
No. As long as the light adequately illuminates the rear plate you do not need to see the actual fixing on the light. In fact the most popular light used is very low-key LED lights that go just above the number plate.
How do you change the license plate light on a 2010 Toyota Corolla?
How do you change a license plate light on a 2010 Toyota Corolla?
- Open the trunk and locate the clips that hold the interior trim panel in place.
- Disconnect the license plate light electric connector.
- Turn the bulb socket a quarter turn counterclockwise and remove it from the assembly.
How do you replace the light bulb on a Toyota Corolla?
Pull the bulb straight out of the socket and install the new bulb. Put the socket back into the assembly and turn it a quarter turn clockwise to lock it into place. Install the light assembly back into the trunk by lining up the claw and pushing in until you hear it click into place.
How to replace the license plate light bulb?
Open your trunk and remove the fasteners for the fabric cover. Inside you will see the back of the plate lamps. Pull the wire straight out carefully, then turn the bulb holder and pull it out. Replace the bulb and put it back together. It took about 20 minutes to do the entire job.
How to replace a light bulb on a lightbulb?
1 Turn the bulb base counterclockwise. 2 Pull the bulb out while pressing the lock release of the connector. 3 Replace the light bulb, and install the bulb base. Align the 3 tabs on the light bulb with the mounting and insert. 4 Turn and secure the bulb base.