What should I do about my road King handlebars?
Mine did after about 10 miles today, the engine light came on, the bike started spitting codes and going in and out of limp mode. The easy and fast solution is to replace the entire throttle assembly with the screaming eagle model. It does not have connectors and the wires are extra long so no extensions are needed.
Why are my handle bars loose on my Harley Davidson?
Each handle bar clamp sits on top of a 1 inch spacer and its this assemby that is loose. I check the manual and the bike for a bolt to tighten and came up blank. Do I have to remove the handle bar clamps to get to this bolt ??
How do you remove trim from a Harley Davidson handlebar?
Remove trim ring from headlight. There is a Phillips head screw at the 6 o’clock position on ring. Remove the 8 screws that hold the headlight in place. Be very careful not to start loosening alignment screw. Remove trim by removing screw found at front of trim.
How big is the handlebar on a Harley Davidson?
I just installed 12.5″ Wild 1’s Chubby Apes on my RK. With a little patience I honestly believe this is a project anyone can do. Below I documented the how too’s with some photos to go with it. This is a good time to inspect your windshield grommets. Mine were pretty chewed up so I replaced them. Remove trim ring from headlight.
Each handle bar clamp sits on top of a 1 inch spacer and its this assemby that is loose. I check the manual and the bike for a bolt to tighten and came up blank. Do I have to remove the handle bar clamps to get to this bolt ??
What to do if your handle bars are loose?
Discussion in ‘ Wheels ‘ started by dangerdan, Jul 15, 2009 . Handle bars appear to be loose. With little effort I can wiggle the hand grips back and forth about an inch. Manual says to remove the inner fairing to get at the handle bar clamp screws. Wow, thats quite labour intensive. Can this job be done by only removing the front fairing.
Why are my handle bars loose on my Springer?
All the factory bikes have rubber mounted risers that have some play in them so the bars will move a bit. That’s the first I have heard of that about the springers having more play. Check the riser bolts under the top triple tree and make sure they are tight.
How do you close the modal on a Harley Davidson?
This modal can be closed by pressing the Escape key or activating the close button. This is a modal window. This modal can be closed by pressing the Escape key or activating the close button. Check out these six basic and advanced maintenance procedures you can perform to keep or improve the rideablity of your motorcycle.