What kind of electrical system does a Yamaha FJ1200 have?
The FJ1200 features a standard 12 volt electrical system. The alternator and starter motor are mounted behind the cylinders. Yamaha’s self cancelling indicator unit is used and a variable resistance gauging system is used to monitor engine oil contents with associated warning lights. A large fuel gauge is provided as is a low level warning light.
Why does my Yamaha FJ 1100 run well when hot?
If there is any problem this is due to the needle height. If the problem is worst when hot then the mixture is too rich. If the bike runs well when hot but there is problems between 4.000 – 7.000 rpm, the mixture is lean.
What should the idle RPM be on a Yamaha FJ 1200?
At this point the bike must keep a good idle and be quick responsive to the throttle. There must be no problems too riding at low speed, at around 2.500 – 3.000 rpm. To perform the following tests I look for a quite and clear straight road, lightly uphill if it is possible to further expose any problem.
What does the oil vent circuit on a Yamaha FJ mean?
Look at the picture: it comes from the Yamaha workshop manual and it represents the oil vent circuit. Well, all that oil will splash around your bike when the crankcase filter saturate (very soon) 3,-without the airbox the carbs and the individuals are holding of the intake manifolds only.
How many turn out does a Yamaha FJ 1100 have?
Workshop manual change the settings to 3 turns out in the last FJ (1991 on). Try 3 turn out in outer cylinders and 3 1/4 at the inner cylinders in whatever would be yours, like a starting point to perform the mixture screws procedure set up.
At this point the bike must keep a good idle and be quick responsive to the throttle. There must be no problems too riding at low speed, at around 2.500 – 3.000 rpm. To perform the following tests I look for a quite and clear straight road, lightly uphill if it is possible to further expose any problem.
What should the pilot screws be on a Yamaha FJ 1200?
TIP: pilot screws setting is 2 turns out from fully in, recommended from FJ 1100 to FJ 1200 1990. Workshop manual change the settings to 3 turns out in the last FJ (1991 on). Try 3 turn out in outer cylinders and 3 1/4 at the inner cylinders in whatever would be yours, like a starting point to perform the mixture screws procedure set up.
What was the price of a 1986 Yamaha FJ 1200?
The Honda offered a smoother engine, water-cooling, shaft drive and, perhaps most importantly, a price tag nearly 10% lower. Things didn’t get any better for Yamaha a year later when Honda lowered the Sabre’s list price even further, and Yamaha just managed to maintain the line on the FJ.