What size Mikuni for Ironhead?
For the money, a 38mm Mikuni is a good choice for 1000cc Ironheads that are stock or slightly modified. But if you have the cash, the S&S Super B or Super E will give you more performance, particularly on the top end.
Is choke up or down on a Mikuni carburetor?
Choke: The lever near the top of the carb is usually called the “choke lever”. Just remember that if the plunger is UP, the choke is ON. If the plunger is DOWN, the choke is OFF.
What kind of carburetor does a Mikuni dirt bike use?
Maple leave Carburetor For Yamaha 50CC Mikuni Aftermarket Motorcycle Dirt Bike TTR50 Carb 2006-2011 Product Description & Features: Brand New Aftermarket Replacement Carburetor Fits car
What should venturi size be on Mikuni bike?
If you put on too big or too small a carb, your bike is going to run like kaka – if at all. Let’s say your bike is basically stock. You pull off the old carb and determine that the venturi size is 28mm on that carburetor (this can be done by measuring with a caliper).
What kind of rebuild kit does a Mikuni use?
Repair Kit for MK BSR 33mm Carburetor Rebuild Kits with Diaphragm Yamaha Big Bear Bruin MK-BSR33 Product Description & Features: Fits for 2000-2004 Yamaha Big Mikuni Super BN SBN Carb Rebuild Kit Jet Ski 38 44 46 Seadoo Yamaha 451460 Product Description & Features: Fits: 1995-1998 Polaris Magnum 425 2×4/4X4;
Are there any Mikuni carbs on a snowmobile?
The very popular, round slide, VM aftermarket series carbs can be found on vintage street bikes, racing motorcycles, snowmobiles as well as experimental aircraft and farm equipment. I mentioned a third group of Mikuni carbs – but they’re not really Mikuni at all. They are cheap, imitation, Mikuni knockoffs.
Where can I buy a Mikuni vm38ss?
Normally Mikuni negotiates a license for the OEM carbs. The OEM carbs, as well as the parts for these carbs, can only be obtained through an OEM dealer. Aftermarket carbs can be obtained through distributors like Niche Cycle. This is a comparison of the OEM VM38-SS and the aftermarket VM38-9.
What are the features of a Mikuni round slide carburetor?
Performance features for the VM series carburetors include a large selection of bore sizes for fuel mixture flow to match any engine modifications. A wide range of tuning components to allow precise fuel mixture metering in any application, at any throttle setting, and under any riding condition.
Is there a carburetor for a vm38ss?
Some new old stock parts are available and can occasionally be found on eBay. The aftermarket, VM38-9 is a very similar carburetor to the 38-SS. Several parts from aftermarket carb will fit the OEM carb and in most cases, it’s not too difficult to swap the carbs out entirely.
Is the vm38-9 the same as the 38-ss?
The aftermarket, VM38-9 is a very similar carburetor to the 38-SS. Several parts from aftermarket carb will fit the OEM carb and in most cases, it’s not too difficult to swap the carbs out entirely. Below is a comparison between an OEM, Yamaha carburetor used on the WR500ZD and an aftermarket VM38-4.