Where is the oil drain on a Kawasaki 550?

Where is the oil drain on a Kawasaki 550?

The oil filter is held behind a cover near the cross-over tube, between the exhaust pipes. The oil drain bolt is positioned a few inches away from the oil filter, near the junction between the exhaust pipes and the mufflers. Start the motorcycle while it is on the center stand and let it idle for three minutes.

How do you replace the oil filter holder?

Using a 13mm socket or wrench, remove the oil pan drain plug. Allow oil to flow into a drain pan. While the oil is draining, remove the engine cover and replace the oil filter element as well as the filter holder O-rings as outlined in Method 1 (Step 3).

Where is the drain plug on a Mercedes Benz?

Be sure the oil pan drain plug is removed when removing the oil filter holder from the filter housing as this will allow additional oil to drain. After the oil has finished draining, re-install the drain plug with a new crush washer and torque the plug to approximately 18 ft-lbs. Figure 10. Location of oil pan drain plug.

What kind of oil do you put in a Kawasaki 550?

Place a funnel into the oil filler on the right side of the motor. Fill the motor with up to three quarts of SAE 10W40 motor oil. Remove the funnel and screw the oil cap into place by hand.

Where is the oil filter on a Kawasaki 550?

Look under the motor to find the oil drain bolt and the oil filter’s housing. The oil filter is held behind a cover near the cross-over tube, between the exhaust pipes. The oil drain bolt is positioned a few inches away from the oil filter, near the junction between the exhaust pipes and the mufflers.

How to change your engine oil and filter?

How to Change Your Engine Oil & Filter in 13 Steps 1) Run your engine.. Warm oil drains faster than cold oil, saving you time, but letting the engine come up to full… 2) Raise the car.. Driving the front wheels onto a pair of ramps is easiest, but you can also use a jack to lift the… 3) Get the

What kind of drain plug does a Kawasaki dirtbike use?

12mm 1.5 12×1.5 US MADE Magnetic Oil Drain Plug Bolt with Crush Washer for many Kawasaki Motorcycle Dirtbike ATV Quad M12-1.5 Very handy! — MADE IN USA — VULCAN TERYX PRAIRIE NINJA KLX KFX BRUTE FORCE ZZR Z BAYOU CONCOURS and many more.

Where is the drain pan on an oil filter?

Move the oil drain pan underneath the oil filter. This is necessary to catch any oil that drains out when you remove the filter. Make sure the pan is located directly below the oil filter. The amount of oil that will drain out when you remove the filter can range from a few drops to 1 liter (1/4 gallon).