Can a stator test good and still be bad?
Yes they can. When it is cool it can test good but when it gets hot it is bad.
What should primary resistance be on Honda CB 750?
PRIMARY RESISTANCE Set the multimeter to measure ohms. Use one test lead on each of the small terminals that attach to the wiring harness. If using stock coils, you should get a reading of approx 5 ohms. If using DOHC or most aftermarket “hot” coils the reading should be about 3 ohms.
How many spark plugs does a Honda CB750 need?
Use one test lead in each of the spark plug wire connectors. You may have to wiggle them around to get them to a spot where you are getting a reading. Depending on the coil you should get a reading of 5Kohms to 20Kohms. I don’t have a manual with me so I will edit later for the actual cb750 specs. If you get no reading, the coil is bad.
How can I check my Honda CB 750 Battery?
Use one meter to check the DC voltage across the battery terminals. For the other, you would use preferably an amp clamp on the + battery cable. This will show you the actual current that is being sent to the battery. There is a table in the service manual to check the actual charging output of the system using these two readings.
Why are my Honda CB 750 choppers not working?
If you get a reading with no wires and no reading without, then the wires are most likely your problem. INSULATION BREAKDOWN These coils have a solid metal core running through them. It is used solely for mounting. It is not a ground. Sometimes the insulation inside the coils starts to break down and the coil will short to the metal core.
PRIMARY RESISTANCE Set the multimeter to measure ohms. Use one test lead on each of the small terminals that attach to the wiring harness. If using stock coils, you should get a reading of approx 5 ohms. If using DOHC or most aftermarket “hot” coils the reading should be about 3 ohms.
Where are the terms of service on a Honda CB750?
For Electrical Parts – Please see our Terms of Service located at the bottom left hand corner of every page. Honda CB750 Contact Point Set (1pc.) – Right Hand Side Honda CB750 Contact Point Set (1pc.) – Left Hand Side This dual coil assembly is plug and play. It comes just as it’s shown in the photo. The coils are already attached to the hardware.
How many coils does a CB750 ignition system need?
CB750’s require 2 coils. Replaces stock factory TCI ignition coils on All 1980 & up models. This coil is not suitable for points or the Boyer-Brandsen system and it will void the Ignition warranty WARNING!!! Do not operate or apply power to the ignition system with one or both spark plugs disconnected.
Use one test lead in each of the spark plug wire connectors. You may have to wiggle them around to get them to a spot where you are getting a reading. Depending on the coil you should get a reading of 5Kohms to 20Kohms. I don’t have a manual with me so I will edit later for the actual cb750 specs. If you get no reading, the coil is bad.