Where does the fuel line go on A weedeater?
The (clear) main fuel line with the filter (filter inside the fuel tank) goes to the bottom of the carburetor (or the elbow shaped nipple). The (clear) fuel intake line runs from the top of the carburetor (straight nipple) and goes to the short post on the back of the primer bulb.
Where is the float needle on a carburetor?
When the carburetor is leaking fuel, it probably has debris caught in the float needle valve area. This valve is located at the point inside the carburetor where the fuel line attaches to the carburetor itself.
Where does the fuel line go in a Husqvarna?
Leave enough slack in this line so that the filter that attaches to the end will rest comfortably at the bottom of the tank. The other fuel line goes from the primer bulb to just inside the tank, (about an.Husqvarna L String Trimmer Question about .
Where can I find a fuel line diagram?
Question Husqvarna L String Trimmer Question about routing fuel lines I am looking for a diagram and instruction to reconnect the fuel. Husqvarna L Exploded View parts lookup by model. Complete Line Cutter Line Cutter $ . Found on Diagram: Fuel Tank.
How are fuel lines attached to a carburetor?
Attach the incoming line on the primer assembly to one of the ports on the carburetor and attach a third fuel line to the other carburetor fuel line port. Submerge the ends of both fuel lines in some 2-cycle fuel and test the line configuration by depressing the primer bulb.
How does a 2 stroke engine fuel line work?
“Local primer” carburetor designs look like the carburetor pictured below. For this 2-stroke engine carburetor design, the primer bulb is built on top of the assembly. The bulb pulls fuel through the filtered fuel line and into the carburetor and then it also pushes it out of the carburetor and out the unfiltered return line.
How do you test the routing of a fuel line?
Test the fuel line routing with the carburetor. Attach the incoming line on the primer assembly to one of the ports on the carburetor and attach a third fuel line to the other carburetor fuel line port. Submerge the ends of both fuel lines in some 2-cycle fuel and test the line configuration by depressing the primer bulb.
Where does the fuel line go in a weed eater?
Pull out about 1″ of fuel line from the fuel cap opening and attach filter. Replace the line back into the tank just like that because you want the fuel filter/line to flop around inside the tank. Now that same line goes from the tank to the bottom connector on the carb.