How big are the teeth on a rear drive belt?
It works great with custom aluminum pulleys and was the # 1 bike builder’s choice when using non- coated pulleys. The rear-drive belt sizes are from 125 teeth up to 140 teeth from 1-1/2″ wide down to 20mm wide. The same goes for the decades of primary belt experience Belt Drives, Ltd. has under its “belt”.
What kind of belt do I need for rear drive pulleys?
When it comes to rear drive pulleys and primary drive systems, BDL more than likely has a belt or a system to fit your American V-Twin motorcycle. *NOTE: 1″ and 1-1/8″ wide belts are designed for custom show only. They are not intended to be used in lieu of a 1-1/2″ wide belt.
How big is a PA rear drive belt?
The PA belt is made with special blended rubber with ultra cord. We have been supplying this belt since 1995. It works great with custom aluminum pulleys and was the # 1 bike builder’s choice when using non- coated pulleys. The rear drive belt sizes are from 125 teeth up to 140 teeth from 1-1/2″ wide down to 20mm wide.
What do you need to know about Harley Davidson drive belts?
Your Harley Davidson’s drive belts and pulleys are among some of the most important parts of the drivetrain. These components are engineered to transfer the engine power from the output shaft of the transmission to the rear wheel. In the majority of cases, these belts are toothed, and pulleys are machined from out of durable, lightweight alloys.
Which is the best pulley for a belt drive Harley Davidson?
Andrews transmission pulleys are made for all sorts of 4-, 5- and 6-speed belt drive models, machined from gear-quality steel and designed to perfectly replace your stock pulley. For higher-end performance, an aluminum Belt Drives LTD pulley offers significant weight savings.
What do you do with a belt with teeth on both sides?
with Teeth on Both Sides Use a single belt to drive three or more pulleys in reversing and serpentine drive systems. These belts have teeth on both sides to transmit power from either side and rotate pulleys in opposite directions. Belts are neoprene with fiberglass reinforcement for quiet operation with high strength.
What kind of belt do you use for serpentine drive?
Often used in reversing and serpentine drive systems, teeth on both sides allow you to rotate pulleys in opposite directions. Belts are quiet-running neoprene and high-strength fiberglass. Neoprene is reinforced with fiberglass for quiet operation with high strength.
Can you switch from belt drive to chain drive on a Harley?
Riders who want to switch from belt drive to chain drive can find Harley conversion sprockets, and we also have compensator sprockets to reduce power spikes. Once the power has gotten to the transmission, our Harley drive pulleys will keep it going to the wheels.