Why is my pool light shorting out?
Check the circuit breaker panel that’s usually found on the side of your house. If the breaker that your pool light is on has been tripped, unplug whatever you just turned on or plugged in and then reset the breaker by turning it all the way off and then back on again. If that doesn’t work, you may have a bad breaker.
How do I test my pool light fixture?
Set your volt-ohm meter to “continuity test” (or lowest ohm scale), and test between the black and white wires to the light (they connect to the bulb). If your light bulb is in good condition, it should read about 3-20 ohms.
How much does it cost to repair a pool light?
Pool Light Replacement Cost The cost to replace pool lights is $625 apiece on average. Pool light repair costs are much more affordable at $65 to $150 each. Just replacing the bulbs is $20 to $100 for each one depending on their type and functions.
What happens if water gets in your pool light?
Chlorine exposure or old age can deteriorate the rubber to warp so that it allows water to reach the light internals. A fixture filled with water can also cause a breaker to trip, so be mindful of that when troubleshooting. Another less likely cause of a pool light fixture leak is a power cord conduit seal leak.
Why does my Pool Light keep shorting out?
Exposure to chlorine and other pool chemicals can erode the seal and water can enter the housing, causing the light to short out. When water enters the housing, your breaker or GFCI may trip. If it appears more than just the gasket has been damaged, the wise thing to do is call the electrician.
What causes a pool light breaker to trip?
This will cause the GFCI to trip. humidity alone can cause this breaker to trip because it’s designed to be very sensitive. If the GFCI trips again once you turn the pool lights on, then you probably still have water inside your light fixture.
What should I do if my pool lights are not working?
In both cases, you need to pull the fixture from the pool in order to continue your troubleshooting process. Go ensure that your circuit breaker to the pool lights, the GFCI and the switch for the pool lights are all turned off.
What causes a pool light to get electrocuted?
It flows through the bonding wire that connects all the metal components together—the pump, heater, lights, slide legs, dive stand, and handrail. Faulty bonding/grounding is the cause of many pool electrocution incidents. Pool lights don’t have to be on to be a potential hazard.
Exposure to chlorine and other pool chemicals can erode the seal and water can enter the housing, causing the light to short out. When water enters the housing, your breaker or GFCI may trip. If it appears more than just the gasket has been damaged, the wise thing to do is call the electrician.
What to do if your swimming pool light is tripped?
If the circuit breaker is tripped, turn off the light to the pool and try turning on the circuit breaker. If it trips immediately, you have a short circuit, in which case you need to get an electrician to correct this problem. If the circuit breaker is not tripped, you can now proceed to check the GFCI (Ground Fault Circuit Interrupter).
How to troubleshoot an underwater pool light fixture?
Make sure the fixture is put together tightly. Hold the entire light fixture under the water of the pool and look for bubbles. If you see them, repeat the process by pulling out the fixture and reassemble it. Put the fixture back into its niche. Screw in the pilot screw or snap in the clip to make sure the light is secure.
Why does my Pool Light keep Tripping the breaker?
The dreaded CLICK of a tripped breaker is an annoying and sometimes befuddling event. Annoying because most of the time the reason for the trip is a mystery, unless of course you just plugged in an appliance that overloaded a circuit. Before we do anything, we want to reset the breaker and also restore the circuit to the point before the trip.