How do you start a Suzuki Z90?
To start the Z90, the procedure is simple. The fuel petcock is a vacuum-style, so you don’t need to turn it on manually. There’s a key and a locking rear brake, both of which have to be on before the Suzuki will turn over. Then you press the electric start and you’re in business.
Why is my ATV not getting a spark?
You will find the proper steps for troubleshooting an ATV that is not getting a spark further down this post. If the spark plug is still dry after cranking the engine for a few seconds, you know that fuel, for some reason, is not getting to the cylinder.
Why does my quad bike not start up?
Having gas just as old as 6 months or so can start to cause corrosion in your fuel system. Make sure if you’re going to let the quad sit for a while that you drain the gas out and start with new gas next time you start it up.
How to start an ATV that wont start?
1 Remove the spark plug from the cylinder-head and connect it to the spark-plug wire or ignition coil. 2 Grab the plug wire and hold the plug about 1/8th of an inch away from the cylinder head. 3 Activate the starter. 4 As the motor turns, you should see repetitive bright blue spark arching from the spark plug to the cylinder head.
What should I do if my bike wont start?
Charge the battery or replace it if it’s dead. Am easy way to test your battery is by checking the voltage-drop with a multimeter as you try starting the bike. If your fully charged battery drops below 11,5 volts under load (while you crank the starter), it needs to be replaced.
Why does my ATV not start after a long charge?
If you’re battery doesn’t hold above 12v after a nice long charge, you may need to replace the battery. If you’re battery isn’t the problem, maybe something else in the electrical system is preventing the quad from starting. Time to check for spark.
Having gas just as old as 6 months or so can start to cause corrosion in your fuel system. Make sure if you’re going to let the quad sit for a while that you drain the gas out and start with new gas next time you start it up.
Why is the spark plug dry on my ATV?
If the spark plug is still dry after cranking the engine for a few seconds, you know that fuel, for some reason, is not getting to the cylinder. It’s often either an issue with the fuel-pump or that the fuel supply line is clogged up somewhere between the gas tank and the carburetor.
Charge the battery or replace it if it’s dead. Am easy way to test your battery is by checking the voltage-drop with a multimeter as you try starting the bike. If your fully charged battery drops below 11,5 volts under load (while you crank the starter), it needs to be replaced.