How long is a Suzuki Vinson 500?
The Suzuki 500 Vinson has an overall length of 82.5 inches, an overall width of 46.1 inches and a height of 48.6 inches with a seat height of 33.9 inches.
What to do about Suzuki Vinson 500 Carb?
I’m working on my brothers’ 2002 Suzuki Vinson 500 . It sat for a few years before I got into it. I’m concentrating on the carb – I replaced orings, needle, etc. and soaked jets, bowl and anything that I could get off the carb that the solution wouldn’t eat. I also removed the tank and flushed it with hot water – it’s clean.
How long has Suzuki Vinson 500 cc sat?
My 2004 Suzuki Vinson 500 cc sat for 13 months. The carb was cleaned thoroughly and the gas was changed. It start right up but idles rough and backfires occassionally. Does anyone know how far to back off the idle screw and the how far to back off the air screw.
What’s the idle adjustment on a Suzuki Vinson?
Start the machine, turn the screw in until the machine begins to stall out, then back the screw out until you reach the point at which the machine idles at the highest RPM. If needed, adjust the idle afterward. The idle adjustment is labeled # 26 on your parts list. Good luck.
How do you set the pilot screw on a Suzuki ATV?
When you are done, set the pilot screw (which is concealed by a plug BTW) at about 1 1/2 to 2 turns out from the fully seated position. Start the machine, turn the screw in until the machine begins to stall out, then back the screw out until you reach the point at which the machine idles at the highest RPM. If needed, adjust the idle afterward.
I’m working on my brothers’ 2002 Suzuki Vinson 500 . It sat for a few years before I got into it. I’m concentrating on the carb – I replaced orings, needle, etc. and soaked jets, bowl and anything that I could get off the carb that the solution wouldn’t eat. I also removed the tank and flushed it with hot water – it’s clean.
My 2004 Suzuki Vinson 500 cc sat for 13 months. The carb was cleaned thoroughly and the gas was changed. It start right up but idles rough and backfires occassionally. Does anyone know how far to back off the idle screw and the how far to back off the air screw.
Start the machine, turn the screw in until the machine begins to stall out, then back the screw out until you reach the point at which the machine idles at the highest RPM. If needed, adjust the idle afterward. The idle adjustment is labeled # 26 on your parts list. Good luck.
When you are done, set the pilot screw (which is concealed by a plug BTW) at about 1 1/2 to 2 turns out from the fully seated position. Start the machine, turn the screw in until the machine begins to stall out, then back the screw out until you reach the point at which the machine idles at the highest RPM. If needed, adjust the idle afterward.