How are throttle cables measured?
The clutch cable and brake line can be measured similarly from their corresponding connection points. When doing this, only measure the length of the housing; do not include the length of the free wire at each end. Subtract the length of your stock cable from the new measurement that you have made with the wire.
How do you measure throttle cable on free play?
To check the throttle free play, hold the grip between your fingers and roll it back and forth until you begin to feel the pull of the cable. Pick a spot on the grip and watch it to measure the free play. If you have trouble visualizing the measurement, hold a metric tape measure up to the grip.
How long should my throttle cable be?
Most motorcycle manufacturers recommend about 2 to 3 millimeters of throttle free play, but over time the cables will stretch and settle into their housings and you’ll end up with more slack.
How to measure motorcycle cables-the aftermarket experience?
Choose the lines and cables with the correct + or – length that you measured. If you have any questions about the process or would like a recommendation on motorcycle cables and lines, our Tech Team at [email protected] will be able to assist you in getting your ride back on the road faster.
How to measure motorcycle cables at Dennis Kirk?
When ordering your cables or lines at Dennis Kirk, enter in the make, model and year of your motorcycle and you will be given the correct fitment options for your bike. Choose the lines and cables with the correct + or – length that you measured.
How do you measure clutch cable on a motorcycle?
For example, take the wire and run it from the throttle housing on the handle bars to the carburetor or the throttle body. The clutch cable and brake line can be measured similarly from their corresponding connection points. Measure the length of your stock cable.
What does throttling data mean on the Internet?
What Is Throttling Data? Throttling is the process of an ISP purposely slowing down an internet user’s data transmission. Sometimes you’ll see lower speeds that are difficult to explain and aren’t attributed to equipment issues.
How are throttle cables adjusted on a motorcycle?
On machines with multiple adjustment points, minor adjustments are made at the throttle cable housing and major adjustments are taken care of on the throttle body/carburetor. The first step to adjusting dual throttle cable machines is to remove any necessary dust covers and identify the accelerator and decelerator cables.
What happens when a throttle cable is ground?
If the throttle has red, blue, and green wires then the blue wire is ground. If the controller has 4.3 through 5 Volt output Voltage to the throttle and the throttle has a 0 Volt output signal – then the throttle, throttle cable, or throttle connector is faulty.
How often should you check your throttle cable?
The throttle cable is a critical component to your bike’s function, but it’s often overlooked. Follow the guidelines below to make sure you’re not stuck with a malfunctioning throttle. Most service manuals suggest checking throttle operation after each race or every 2.5 hours of operation.
How do you check the throttle grip on a motorcycle?
Do your best to visually follow the routing the of the throttle cable to inspect for damage and wear regularly. Throttle cable free play is typically checked by measuring the amount of throttle grip movement relative to a fixed point on the throttle cable housing. Most makes/models specify 2-3mm of throttle grip free play.