Where is the timing light on an Evo?
Connect the inductive pickup probe of the timing light to the front cylinder spark plug wire. Start the engine, and run it at idle. Point the timing light into the timing inspection hole.
Where is the advance timing mark on a Harley Davidson?
Aim timing light into timing inspection hole. Front cylinder advance timing mark should be centered in timing inspection hole. If not, see ADJUSTMENT below. 6. Set engine slow idle speed as described in Step 4 with engine running at normal operating temperature and with enrichener control knob pushed in fully.
When to replace Ignition module on Harley Davidson Evo?
These units will also replace the OEM HD®factory ignition module and sensor used on 1983 and later Harley-Davidson EVO motors. It is also an ideal upgrade for early electronic and breaker-point systems that require a mechanical advancer.
What happens when you change the ignition timing on a Harley Davidson?
As a Harley-Davidson engine ages, you must adjust the ignition timing to compensate for the wear of internal engine parts. Setting the timing correctly keeps your motorcycle running smoothly and efficiently. Maladjusted timing may result in sluggish performance, poor fuel economy and possible damage to internal engine components.
How to set static timing on evo ignition?
Evo Timing marks-Howto set static timing. Discussion in ‘ Softail Models ‘ started by bbarbee, Feb 25, 2010 . I’m installing a dyna s ignition. What timing marks are what?
Aim timing light into timing inspection hole. Front cylinder advance timing mark should be centered in timing inspection hole. If not, see ADJUSTMENT below. 6. Set engine slow idle speed as described in Step 4 with engine running at normal operating temperature and with enrichener control knob pushed in fully.
How to set static timing on a Harley?
Here is what I suggest: Collapse the pushrod covers on the front cylinder’s pushrods Jack up the rear of the bike so you can rotate the rear wheel Put the tranny in 4th or 5th gear and take out the timing mark plug You should see the exhaust rod rise and then come back down and then immediately the intake will rise and start to come down
Is it easier to see the timing bar on an Evo?
Tighten the timing plate screws, and install the cover. The process is easier with 2 people. Also, it is easier to see the timing bar if painted with white or yellow paint. Static timing instructions will vary depending on what you are running for an ignition.