What should the vacuum be on a Suzuki GS motorcycle?
Loosen the locknut between #1 and #2 cylinders, and adjust the vacuum to 11.25 in Hg (28.5 cm Hg) for #1 cylinder. Tighten locknut being careful not to move the set screw.
What kind of rubbers does a Suzuki carb use?
GS1000 Inlet Rubbers. Oversize. set of 4. Cv type carb to head rubber. Suzuki GSX1100 efe inlet rubbers oem. Suzuki GSX1100 EX SZ Katana inlet rubbers oem. Suzuki GS850GN 1979 shaft oem inlet rubbers. Suzuki GS1000 E S oem inlet rubbers. Suzuki GS750 77/79 oem inlet rubbers. Suzuki GS550 81 on inlet rubbers oem.
What should idle speed be on Suzuki GS?
Once the idle mixture is correct, set the idle speed to 1200 RPM (or other speed as described in the shop manual) using the adjustment knob located between the airbox and the carburetors. Cylinder #3 should draw about 10 in Hg (24.5 cm Hg). This is your baseline measure.
Are there any Suzuki carburettors left for sale?
Only 1 left. WEBER DGV/DGAV/DGEV CARBURETTOR MANIFOLD ADAPTER PLATE AND LINKAGE KIT SUZUKI… New Genuine Suzuki Choke Cable 15930B80420 samurai SJ ?
Loosen the locknut between #1 and #2 cylinders, and adjust the vacuum to 11.25 in Hg (28.5 cm Hg) for #1 cylinder. Tighten locknut being careful not to move the set screw.
Once the idle mixture is correct, set the idle speed to 1200 RPM (or other speed as described in the shop manual) using the adjustment knob located between the airbox and the carburetors. Cylinder #3 should draw about 10 in Hg (24.5 cm Hg). This is your baseline measure.
What should I change in my Suzuki GS bike?
Replace the sparkplug in cylinder #3. Start the bike, and fine tune the idle mixture on #2. Loosen the locknut between #2 and #3 cylinders, and adjust the vacuum to 10 in Hg (25.5 cm Hg) for both cylinders. Tighten locknut being careful not to move the set screw.
What should cylinder 3 draw in Suzuki GS?
Cylinder #3 should draw about 10 in Hg (24.5 cm Hg). This is your baseline measure. If the motor is not drawing this vacuum, double check that the idle RPM and mixture are correct; a rich cylinder will not create the full vacuum.