How do you install Softail shocks?
How to Install Shocks on a Softail Motorcycle
- Raise the bike with a bike lift. Place the lift toward the rear of the bike frame so it will lift the rear tire off the ground.
- Install the frame end of the left shock first. Ensure that the shock eye and frame holes are clean and free of debris or oil.
Where can I get shock bolts and pins?
Shock Mount Bolts, Upper, 5/16 in. Fine Threads, Steel, Zinc Plated, Ford, Set of 4 Part Number: SDK-373406-SK More Detail… This part is normally shipped directly from the manufacturer / Supplier. Shock Bolts and Pins, Shock Installation Kit, Front, 14mm x 5/8 in. Stud, Lower Bolt, Washers, Nuts, Chevrolet, GMC, RWD, Kit
Do you need to tighten your shock bolts?
Don’t over-tighten your shock bolts! Tightening fasteners to their rated spec is second nature for most of us, especially anyone with mechanical experience. But tightening shock bolts to “spec” will destroy shocks on these machines.
What should I do when installing a new shock absorber?
When installing new shocks, the goal is to tighten them just enough that there is no play or chattering in the suspension over bumps. But not so much that it adds any noticeable resistance to the shock’s pivot points. After adjusting the tension on each bolt, bounce the suspension by hand.
Are there any shock mounting bolts left on Amazon?
Only 11 left in stock – order soon. . Only 3 left in stock – order soon. . . Only 1 left in stock – order soon. . . Only 10 left in stock – order soon.
How do you install shocks on a softail motorcycle?
Lightly grease the smooth portion of the shock bolt, but leave the threads clean. Install the washer and spacer onto the shock bolt, and apply Loctite to the threads. Put it through a shock eye and into the frame hole. Torque it to factory specifications for your year Softail.
What kind of wrench do you need to mount a Harley Davidson shock?
The bottom mounting bolts require the use of a 3/4″ or 19mm wrench to hold the nut on the backside of the shock. Using your ratchet and socket, loosen the bottom mounting bolt while countering the nut with your wrench.
How to install shocks on a Harley Davidson Sportster?
Adjust the jack to raise or lower the swingarm to a position that allows for alignment of the shock eyelet to the shock mount. Apply Threadlocker to the threads of the bolt. Install the bolt and nut. Figure 8. Aligning shock eyelet and installing mounting bolt. Torque the upper and lower shock bolts to 45 to 50 ft/lbs. Figure 9.
What kind of wrench do I need for softtail shock adjustment?
Softtail Shock Adjustment You will need a spanner wrench (Harley Davidson part # 94448-82B) and a large 1-1/16″ wrench. The 1-1/16″ wrench is used for the jam nut. It is a good idea to purchase a cheap 1-1/16″ wrench that can be cut shorter to access the jam nut.