Menu

Navigation

Should Choke be up or down?

Posted on by Arif Clayton

Should Choke be up or down?

The choke should be off (open or down) when you’re riding. Also Know, what is choke position? Similar to the throttle, the choke plate rotates from a horizontal to vertical position to open up the passageway and allow more air to get by.

Can a key fob be used to start a bike?

You are not going to believe this – but – it was the battery in the key fob. The bike has to have a signal from the key fob before it will allow the bike to start. The TSSM is the – turn signal security module ( Japan & Korean markets only) I asked the dealer is they could test the ECM and they said yes if it on the bike.

Where does the Blk / red wire go on a bike?

Try jumping 12 volts directly from the battery to where this blk/red wire enters the relay plug. See what the outcome is. You may also want to try this with the blk/red wire removed from the relay plug. If you can start the bike this way; the start switch is probably bad, or a wire may be damaged. Let us know what you find.

Why does my Harley Davidson bike not start?

If you can start the bike this way; the start switch is probably bad, or a wire may be damaged. Let us know what you find. Sounds like you know what you are doing. You are not going to believe this – but – it was the battery in the key fob. The bike has to have a signal from the key fob before it will allow the bike to start.

Is there a problem with my FLHX bike alarm?

I have a 2007 flhx… I have a 2007 flhx , and the alarm system will not de-arm with the key-fob. tried second key-fob also. battery is good and check bike battery. What can i do to trouble shoot this problem. I can deactivate with the manual code with turn-signal switches.

What’s the problem with the CARB on a Harley?

The even bigger problem is the rubber manifold boot gasket to the inside of the carb. The original Harley rubber boot is noticeably more pliable and about 20% thicker on the side walls. I placed the replacement boot over the intake manifold and pressed the carb in place, and it literally slid into the boot with no resistance whatsoever.

Can a CV carburetor boot lift off the CARB?

Luckily, my old original one, which was noticavbly thicker and a small I.D. at the opening, worked just fine. the replacement boot would lift right off the carb with the first acceleration actuation. The even bigger problem is the rubber manifold boot gasket to the inside of the carb.

Can a new accelerator boot be installed on a carb?

The accelerator rod boot was poorly made and it was WAY too loose to stay on the carb body where it mounts and the rod passes through it. Luckily, my old original one, which was noticavbly thicker and a small I.D. at the opening, worked just fine. the replacement boot would lift right off the carb with the first acceleration actuation.

I have a 2007 flhx… I have a 2007 flhx , and the alarm system will not de-arm with the key-fob. tried second key-fob also. battery is good and check bike battery. What can i do to trouble shoot this problem. I can deactivate with the manual code with turn-signal switches.

Should choke be up or down?

Posted on by Arif Clayton

Should choke be up or down?

If you have the NT carburetor the choke is on (closed) when the lever is up. If the engine isn’t running it doesn’t make any difference where it is. The choke should be off (open or down) when you’re riding. Just remember to shut off the fuel petcock when the bike is parked.

How do you test choke pull-off?

Testing with a vacuum pump – Apply 15″ of vacuum to the vacuum line going to the choke pull-off. The pull-off should retract all the way and for at least 20-30 seconds. If the plunger isn’t retracted completely, replace the pull-off. Testing with the engine running – Your engine should have at least 15″ of vacuum.

What kind of transmission does a Hyundai Accent have?

With engines, either a five-speed manual gearbox or a four-speed automatic transmission is aggregated. In all countries of sale, except for Russia and China, this model is referred to as Hyundai Accent (Korea, USA, Canada, Australia, Ukraine, Kazakhstan, etc.).

What is the ECU on a Hyundai Accent?

ECU– Your Accent’s Engine Control Unit (ECU for short) is the computer that takes all of the information that the vehicle sensors compile and uses it to control the vehicle systems, and sends important vehicular telemetry data to the driver via the instrument cluster.

What should I do if my Hyundai Accent stops running?

I have a 2004 Hyndai Accent and basically has the same issues as those mentioned. It dies after 10-15 minutes while on the highway. It loses power like there is no fuel. Press the gas pedal and then it re-engages again….Replaced the crankshaft sensor but no luck. No engine light appears so I guess the sensor is good. What else should I do?

Are there PDF manuals for the Hyundai Accent?

Hyundai Accent PDF Workshop, Service and Repair manuals, Wiring Diagrams, Parts Catalogue, Fault codes free download!! Hyundai Accent (in some countries is sold under the name Verna, in Russia the model is called Solaris, in Australia until 2000 with the name Excel) – a subcompact car manufactured by the South Korean company Hyundai Motor Company.

What’s the problem with a 2008 Hyundai Accent?

3 people found this helpful. 2008 Hyundai accent was coming to a stop sign felt a litte pull stop at the sign proceeded to give gas wouldn’t go turned off the car restarted it won’t start at all what could be the problem 46 people found this helpful.

What’s the price of a 2000 Hyundai Accent?

2000 Hyundai Accent appraisal values can range from $130 – $738. Find out what your car is really worth in minutes. Reliable basic transportation. Bought new as a drive-to-work car.

Is the Hyundai Accent a good car to drive?

While not the thrill ride of, say, a Honda Civic Si coupe, the Accent goes about its business in an orderly fashion without annoying the driver with horrendous flaws or unpleasant surprises. In fact, upon first entering the car, the surprises were actually quite pleasant.

How to change crankshaft angle on Hyundai Accent?

There’s a wire clip hold the plug into the socket for the sensor, just get a small flat head screw driver and pry it up then it will slide off…make sure to put the clip back on when you install the new sensor. 45 people found this helpful. Just changed the Crankshaft Angle Censor on my 1997 (manual) hyundai Excel.