How to remove Harley turn signals?
Loosen the Allen head bolt located under the left or right handlebar switch pod, using a 1/4-inch Allen wrench. Pull the front turn signal ball post out from the bottom of the switch pod, then pull the turn signal wiring out from the motorcycle’s frame until the turn signal has been removed completely.
Where can I buy a Harley Davidson turn signal?
Motorcycle turn signals from Harley-Davidson are anything but basic. Shop our selection of bullet and LED motorcycle turn signals online. Motorcycle Turn Signals | Harley-Davidson USA
Why is the start button not working on my Harley Davidson?
If you did NOT read 12 volts, you would have to go back to the TSSM and hot wire (bypass it) in order to determine where the problem was. Also testing the start button would be something to check also. The key point to remember is that the “Start Relay Control” comes from the TSSM.
Can a Dyna turn signal module go out?
I have a ’91 Dyna, and yes, I had the module go out on me. On inspection, it looked partially melted or burned. But before you go spend about a hundred dollars (HD, get it!!), make sure that both bulbs on that side are OK. When one bulb goes, the indicator and the other bulb should stay on steady when you try that side turn signal.
What to do if left turn signal is not working?
If you don’t have a manual, then have a look at the TS module and hopefully the pins are labled. If you apply 12 vdc to the (Lt out) pin -the Left turn signal lights should come on. (you’ve just bypassed the TSM) Next.. connect a jumper from (Lt in)pin to (Lt out) pin & press the Left turn signal switch.
What are the turnsignals on a Harley Davidson?
1) Turnsignals all stock means the front signal lights one of the two filaments in the front; the rear signal lights use single filiament lights.
Why are the turn signals on my Harley not working?
2) If you have LED type bulbs, someone replaced the turnsignals BEFORE you and may not have added the recommended load equilizer (simulates load of filament type bulbs), and never got the problem fixed just right, and if left alone it can “fry” the TSM/TSSM. Hopefully you have not gotton to this point and have to replace the module.
Why is my turn signal not working on my Road King?
Im going through the same thing right now with my 15 road king, I ordered a new harness got it plugged it in now neutral light comes on with switch turned off or on, everyone said change wiring harness mine signals work but lt turn and high beam don’t, Help Schmiddty? Click to expand… I haven’t run into this problem yet.
If you did NOT read 12 volts, you would have to go back to the TSSM and hot wire (bypass it) in order to determine where the problem was. Also testing the start button would be something to check also. The key point to remember is that the “Start Relay Control” comes from the TSSM.